ipmi: Add docs for the IPMI IPMB driver

Describe how to use the IPMI IPMB driver, including it's quirks.

Signed-off-by: Corey Minyard <minyard@acm.org>
Tested-by: Andrew Manley <andrew.manley@sealingtech.com>
Reviewed-by: Andrew Manley <andrew.manley@sealingtech.com>

1 files changed, 39 insertions, 0 deletions

diff --git a/Documentation/driver-api/ipmi.rst b/Documentation/driver-api/ipmi.rst
index c9cb5669bc4c..e224e47b6b09 100644
--- a/Documentation/driver-api/ipmi.rst
+++ b/Documentation/driver-api/ipmi.rst
@@ -591,6 +591,45 @@ web page.
 The driver supports a hot add and remove of interfaces through the I2C
 sysfs interface.
 
+The IPMI IPMB Driver
+--------------------
+
+This driver is for supporting a system that sits on an IPMB bus; it
+allows the interface to look like a normal IPMI interface.  Sending
+system interface addressed messages to it will cause the message to go
+to the registered BMC on the system (default at IPMI address 0x20).
+
+It also allows you to directly address other MCs on the bus using the
+ipmb direct addressing.  You can receive commands from other MCs on
+the bus and they will be handled through the normal received command
+mechanism described above.
+
+Parameters are::
+
+  ipmi_ipmb.bmcaddr=<address to use for system interface addresses messages>
+	ipmi_ipmb.retry_time_ms=<Time between retries on IPMB>
+	ipmi_ipmb.max_retries=<Number of times to retry a message>
+
+Loading the module will not result in the driver automatcially
+starting unless there is device tree information setting it up.  If
+you want to instantiate one of these by hand, do::
+
+  echo ipmi-ipmb <addr> > /sys/class/i2c-dev/i2c-<n>/device/new_device
+
+Note that the address you give here is the I2C address, not the IPMI
+address.  So if you want your MC address to be 0x60, you put 0x30
+here.  See the I2C driver info for more details.
+
+Command bridging to other IPMB busses through this interface does not
+work.  The receive message queue is not implemented, by design.  There
+is only one receive message queue on a BMC, and that is meant for the
+host drivers, not something on the IPMB bus.
+
+A BMC may have multiple IPMB busses, which bus your device sits on
+depends on how the system is wired.  You can fetch the channels with
+"ipmitool channel info <n>" where <n> is the channel, with the
+channels being 0-7 and try the IPMB channels.
+
 Other Pieces
 ------------