Merge branch 'for-3.20' of git://git.kernel.org/pub/scm/linux/kernel/git/tj/libata

Pull libata changes from Tejun Heo:
 "Mostly driver-specific changes.  Nothing too noteworthy.

  This pull request contains three merges from for-3.19-fixes.  The
  first two are to pull ahci_xgene and sata_dwc_460ex fix commits which
  are depended upon by later changes.  The last one is to pull in a fix
  patch which missed the v3.19-rc window"

* 'for-3.20' of git://git.kernel.org/pub/scm/linux/kernel/git/tj/libata: (24 commits)
  ahci_xgene: Fix the dma state machine lockup for the ATA_CMD_SMART PIO mode command.
  ata: libahci: Use of_platform_device_create only if supported
  sata_mv: Delete unnecessary checks before the function call "phy_power_off"
  ata: Delete unnecessary checks before the function call "pci_dev_put"
  ata: pata_platform: fix owner module reference mismatch for scsi host
  ata: ahci_platform: fix owner module reference mismatch for scsi host
  pata_pdc2027x: Use 64-bit timekeeping
  ata: libahci: Fix devres cleanup on failure
  ata: libahci: Allow using multiple regulators
  Documentation: bindings: Add the regulator property to the sub-nodes AHCI bindings
  ata: libahci: Clean-up the ahci_platform_en/disable_phys functions
  sata_rcar: extend PM methods
  sata_dwc_460ex: disable compilation on ARM and ARM64
  ata: libata-core: Remove unused function
  sata_dwc_460ex: convert to devm_kzalloc in ->probe()
  sata_dwc_460ex: remove extra message
  sata_dwc_460ex: use np local variable in ->probe()
  sata_dwc_460ex: fix most of the sparse warnings
  sata_dwc_460ex: enable COMPILE_TEST for the driver
  sata_dwc_460ex: remove redundant dev_set_drvdata
  ...

1 files changed, 6 insertions, 3 deletions

diff --git a/Documentation/devicetree/bindings/ata/ahci-platform.txt b/Documentation/devicetree/bindings/ata/ahci-platform.txt
index 4ab09f2202d4..c2340eeeb97f 100644
--- a/Documentation/devicetree/bindings/ata/ahci-platform.txt
+++ b/Documentation/devicetree/bindings/ata/ahci-platform.txt
@@ -37,9 +37,10 @@ Required properties when using sub-nodes:
 
 
 Sub-nodes required properties:
-- reg               : the port number
-- phys              : reference to the SATA PHY node
-
+- reg		    : the port number
+And at least one of the following properties:
+- phys		    : reference to the SATA PHY node
+- target-supply    : regulator for SATA target power
 
 Examples:
         sata@ffe08000 {
@@ -68,10 +69,12 @@ With sub-nodes:
 		sata0: sata-port@0 {
 			reg = <0>;
 			phys = <&sata_phy 0>;
+			target-supply = <&reg_sata0>;
 		};
 
 		sata1: sata-port@1 {
 			reg = <1>;
 			phys = <&sata_phy 1>;
+			target-supply = <&reg_sata1>;;
 		};
 	};