diff options
| author | Sean Anderson | 2022-09-02 18:02:39 -0400 |
|---|---|---|
| committer | David S. Miller | 2022-09-05 14:30:42 +0100 |
| commit | 05ad5d4581c3c1cc724fe50d4652833fb9f3037b (patch) | |
| tree | aaf17b642d240573d059b468e800e8e288ac879f /Documentation | |
| parent | ab526eaa84b90963a54f4f22891a11ef7288196c (diff) | |
net: phy: Add 1000BASE-KX interface mode
Add 1000BASE-KX interface mode. This 1G backplane ethernet as described in
clause 70. Clause 73 autonegotiation is mandatory, and only full duplex
operation is supported.
Although at the PMA level this interface mode is identical to
1000BASE-X, it uses a different form of in-band autonegation. This
justifies a separate interface mode, since the interface mode (along
with the MLO_AN_* autonegotiation mode) sets the type of autonegotiation
which will be used on a link. This results in more than just electrical
differences between the link modes.
With regard to 1000BASE-X, 1000BASE-KX holds a similar position to
SGMII: same signaling, but different autonegotiation. PCS drivers
(which typically handle in-band autonegotiation) may only support
1000BASE-X, and not 1000BASE-KX. Similarly, the phy mode is used to
configure serdes phys with phy_set_mode_ext. Due to the different
electrical standards (SFI or XFI vs Clause 70), they will likely want to
use different configuration. Adding a phy interface mode for
1000BASE-KX helps simplify configuration in these areas.
Signed-off-by: Sean Anderson <sean.anderson@seco.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Diffstat (limited to 'Documentation')
| -rw-r--r-- | Documentation/networking/phy.rst | 6 |
1 files changed, 6 insertions, 0 deletions
diff --git a/Documentation/networking/phy.rst b/Documentation/networking/phy.rst index 712e44caebd0..06f4fcdb58b6 100644 --- a/Documentation/networking/phy.rst +++ b/Documentation/networking/phy.rst @@ -317,6 +317,12 @@ Some of the interface modes are described below: PTP-enabled PHYs. This mode isn't compatible with QSGMII, but offers the same capabilities in terms of link speed and negociation. +``PHY_INTERFACE_MODE_1000BASEKX`` + This is 1000BASE-X as defined by IEEE 802.3 Clause 36 with Clause 73 + autonegotiation. Generally, it will be used with a Clause 70 PMD. To + contrast with the 1000BASE-X phy mode used for Clause 38 and 39 PMDs, this + interface mode has different autonegotiation and only supports full duplex. + Pause frames / flow control =========================== |