i2c: Move at24 to drivers/misc/eeprom

As drivers/i2c/chips is going to go away, move the driver to
drivers/misc/eeprom. Other eeprom drivers may be moved here later, too.
Update Kconfig text to specify this driver as I2C.

Signed-off-by: Wolfram Sang <w.sang@pengutronix.de>
Signed-off-by: Jean Delvare <khali@linux-fr.org>

1 files changed, 0 insertions, 26 deletions

diff --git a/drivers/i2c/chips/Kconfig b/drivers/i2c/chips/Kconfig
index b9bef04b7be4..b58e77056b2e 100644
--- a/drivers/i2c/chips/Kconfig
+++ b/drivers/i2c/chips/Kconfig
@@ -16,32 +16,6 @@ config DS1682
 	  This driver can also be built as a module.  If so, the module
 	  will be called ds1682.
 
-config AT24
-	tristate "EEPROMs from most vendors"
-	depends on SYSFS && EXPERIMENTAL
-	help
-	  Enable this driver to get read/write support to most I2C EEPROMs,
-	  after you configure the driver to know about each EEPROM on
-	  your target board.  Use these generic chip names, instead of
-	  vendor-specific ones like at24c64 or 24lc02:
-
-	     24c00, 24c01, 24c02, spd (readonly 24c02), 24c04, 24c08,
-	     24c16, 24c32, 24c64, 24c128, 24c256, 24c512, 24c1024
-
-	  Unless you like data loss puzzles, always be sure that any chip
-	  you configure as a 24c32 (32 kbit) or larger is NOT really a
-	  24c16 (16 kbit) or smaller, and vice versa. Marking the chip
-	  as read-only won't help recover from this. Also, if your chip
-	  has any software write-protect mechanism you may want to review the
-	  code to make sure this driver won't turn it on by accident.
-
-	  If you use this with an SMBus adapter instead of an I2C adapter,
-	  full functionality is not available.  Only smaller devices are
-	  supported (24c16 and below, max 4 kByte).
-
-	  This driver can also be built as a module.  If so, the module
-	  will be called at24.
-
 config SENSORS_EEPROM
 	tristate "EEPROM reader"
 	depends on EXPERIMENTAL