diff options
| -rw-r--r-- | include/linux/pinctrl/pinconf-generic.h | 4 |
1 files changed, 2 insertions, 2 deletions
diff --git a/include/linux/pinctrl/pinconf-generic.h b/include/linux/pinctrl/pinconf-generic.h index 6aeb711f7cd1..188db8d84162 100644 --- a/include/linux/pinctrl/pinconf-generic.h +++ b/include/linux/pinctrl/pinconf-generic.h @@ -90,6 +90,7 @@ struct pinctrl_map; * value on the line. Use argument 1 to indicate high level, argument 0 to * indicate low level. (Please see Documentation/driver-api/pinctl.rst, * section "GPIO mode pitfalls" for a discussion around this parameter.) + * @PIN_CONFIG_PERSIST_STATE: retain pin state across sleep or controller reset * @PIN_CONFIG_POWER_SOURCE: if the pin can select between different power * supplies, the argument to this parameter (on a custom format) tells * the driver which alternative power source to use. @@ -101,7 +102,6 @@ struct pinctrl_map; * or latch delay (on outputs) this parameter (in a custom format) * specifies the clock skew or latch delay. It typically controls how * many double inverters are put in front of the line. - * @PIN_CONFIG_PERSIST_STATE: retain pin state across sleep or controller reset * @PIN_CONFIG_END: this is the last enumerator for pin configurations, if * you need to pass in custom configurations to the pin controller, use * PIN_CONFIG_END+1 as the base offset. @@ -127,11 +127,11 @@ enum pin_config_param { PIN_CONFIG_LOW_POWER_MODE, PIN_CONFIG_OUTPUT_ENABLE, PIN_CONFIG_OUTPUT, + PIN_CONFIG_PERSIST_STATE, PIN_CONFIG_POWER_SOURCE, PIN_CONFIG_SLEEP_HARDWARE_STATE, PIN_CONFIG_SLEW_RATE, PIN_CONFIG_SKEW_DELAY, - PIN_CONFIG_PERSIST_STATE, PIN_CONFIG_END = 0x7F, PIN_CONFIG_MAX = 0xFF, }; |