1 files changed, 32 insertions, 0 deletions
diff --git a/Documentation/devicetree/bindings/input/atmel,maxtouch.yaml b/Documentation/devicetree/bindings/input/atmel,maxtouch.yaml
index 8c6418f76e94..3ec579d63570 100644
--- a/Documentation/devicetree/bindings/input/atmel,maxtouch.yaml
+++ b/Documentation/devicetree/bindings/input/atmel,maxtouch.yaml
@@ -39,6 +39,13 @@ properties:
       (active low). The line must be flagged with
       GPIO_ACTIVE_LOW.
 
+  wake-gpios:
+    maxItems: 1
+    description:
+      Optional GPIO specifier for the touchscreen's wake pin
+      (active low). The line must be flagged with
+      GPIO_ACTIVE_LOW.
+
   linux,gpio-keymap:
     $ref: /schemas/types.yaml#/definitions/uint32-array
     description: |
@@ -53,6 +60,29 @@ properties:
       or experiment to determine which bit corresponds to which input. Use
       KEY_RESERVED for unused padding values.
 
+  atmel,wakeup-method:
+    $ref: /schemas/types.yaml#/definitions/uint32
+    description: |
+      The WAKE line is an active-low input that is used to wake up the touch
+      controller from deep-sleep mode before communication with the controller
+      could be started. This optional feature used to minimize current
+      consumption when the controller is in deep sleep mode. This feature is
+      relevant only to some controller families, like mXT1386 controller for
+      example.
+
+      The WAKE pin can be connected in one of the following ways:
+       1) left permanently low
+       2) connected to the I2C-compatible SCL pin
+       3) connected to a GPIO pin on the host
+    enum:
+      - 0 # ATMEL_MXT_WAKEUP_NONE
+      - 1 # ATMEL_MXT_WAKEUP_I2C_SCL
+      - 2 # ATMEL_MXT_WAKEUP_GPIO
+    default: 0
+
+  wakeup-source:
+    type: boolean
+
 required:
   - compatible
   - reg
@@ -63,6 +93,7 @@ additionalProperties: false
 examples:
   - |
     #include <dt-bindings/interrupt-controller/irq.h>
+    #include <dt-bindings/input/atmel-maxtouch.h>
     #include <dt-bindings/gpio/gpio.h>
     i2c {
       #address-cells = <1>;
@@ -75,6 +106,7 @@ examples:
         reset-gpios = <&gpio 27 GPIO_ACTIVE_LOW>;
         vdda-supply = <&ab8500_ldo_aux2_reg>;
         vdd-supply = <&ab8500_ldo_aux5_reg>;
+        atmel,wakeup-method = <ATMEL_MXT_WAKEUP_I2C_SCL>;
       };
     };