diff options
Diffstat (limited to 'Documentation')
| -rw-r--r-- | Documentation/devicetree/bindings/iio/imu/adi,adis16480.txt | 36 |
1 files changed, 36 insertions, 0 deletions
diff --git a/Documentation/devicetree/bindings/iio/imu/adi,adis16480.txt b/Documentation/devicetree/bindings/iio/imu/adi,adis16480.txt index 39ab016658c0..ed7783f45233 100644 --- a/Documentation/devicetree/bindings/iio/imu/adi,adis16480.txt +++ b/Documentation/devicetree/bindings/iio/imu/adi,adis16480.txt @@ -34,6 +34,39 @@ Optional properties: signal. - reset-gpios: must be the device tree identifier of the RESET pin. As the line is active low, it should be marked GPIO_ACTIVE_LOW. +- clocks: phandle to the external clock. Should be set according to + "clock-names". + If this field is left empty together with the "clock-names" field, then + the internal clock is used. +- clock-names: The name of the external clock to be used. Valid values are: + * sync: In sync mode, the internal clock is disabled and the frequency + of the external clock signal establishes therate of data + collection and processing. See Fig 14 and 15 in the datasheet. + The clock-frequency must be: + * 3000 to 4500 Hz for adis1649x devices. + * 700 to 2400 Hz for adis1648x devices. + * pps: In Pulse Per Second (PPS) Mode, the rate of data collection and + production is equal to the product of the external clock + frequency and the scale factor in the SYNC_SCALE register, see + Table 154 in the datasheet. + The clock-frequency must be: + * 1 to 128 Hz for adis1649x devices. + * This mode is not supported by adis1648x devices. + If this field is left empty together with the "clocks" field, then the + internal clock is used. +- adi,ext-clk-pin: The DIOx line to be used as an external clock input. + Valid values are: + * DIO1 + * DIO2 + * DIO3 + * DIO4 + Each DIOx pin supports only one function at a time (data ready line + selection or external clock input). When a single pin has two + two assignments, the enable bit for the lower priority function + automatically resets to zero (disabling the lower priority function). + Data ready has highest priority. + If this field is left empty, DIO2 is assigned as default external clock + input pin. Example: @@ -46,4 +79,7 @@ Example: interrupts = <25 IRQF_TRIGGER_FALLING>; interrupt-parent = <&gpio>; interrupt-names = "DIO2"; + clocks = <&adis16495_sync>; + clock-names = "sync"; + adi,ext-clk-pin = "DIO1"; }; |