diff options
Diffstat (limited to 'Documentation')
-rw-r--r-- | Documentation/devicetree/bindings/net/amd-xgbe.txt | 12 | ||||
-rw-r--r-- | Documentation/devicetree/bindings/net/dsa/dsa.txt | 9 | ||||
-rw-r--r-- | Documentation/networking/bonding.txt | 7 | ||||
-rw-r--r-- | Documentation/networking/ip-sysctl.txt | 23 |
4 files changed, 42 insertions, 9 deletions
diff --git a/Documentation/devicetree/bindings/net/amd-xgbe.txt b/Documentation/devicetree/bindings/net/amd-xgbe.txt index 41354f730beb..26efd526d16c 100644 --- a/Documentation/devicetree/bindings/net/amd-xgbe.txt +++ b/Documentation/devicetree/bindings/net/amd-xgbe.txt @@ -7,7 +7,10 @@ Required properties: - PCS registers - interrupt-parent: Should be the phandle for the interrupt controller that services interrupts for this device -- interrupts: Should contain the amd-xgbe interrupt +- interrupts: Should contain the amd-xgbe interrupt(s). The first interrupt + listed is required and is the general device interrupt. If the optional + amd,per-channel-interrupt property is specified, then one additional + interrupt for each DMA channel supported by the device should be specified - clocks: - DMA clock for the amd-xgbe device (used for calculating the correct Rx interrupt watchdog timer value on a DMA channel @@ -23,6 +26,9 @@ Optional properties: - mac-address: mac address to be assigned to the device. Can be overridden by UEFI. - dma-coherent: Present if dma operations are coherent +- amd,per-channel-interrupt: Indicates that Rx and Tx complete will generate + a unique interrupt for each DMA channel - this requires an additional + interrupt be configured for each DMA channel Example: xgbe@e0700000 { @@ -30,7 +36,9 @@ Example: reg = <0 0xe0700000 0 0x80000>, <0 0xe0780000 0 0x80000>; interrupt-parent = <&gic>; - interrupts = <0 325 4>; + interrupts = <0 325 4>, + <0 326 1>, <0 327 1>, <0 328 1>, <0 329 1>; + amd,per-channel-interrupt; clocks = <&xgbe_dma_clk>, <&xgbe_ptp_clk>; clock-names = "dma_clk", "ptp_clk"; phy-handle = <&phy>; diff --git a/Documentation/devicetree/bindings/net/dsa/dsa.txt b/Documentation/devicetree/bindings/net/dsa/dsa.txt index a62c889aafca..e124847443f8 100644 --- a/Documentation/devicetree/bindings/net/dsa/dsa.txt +++ b/Documentation/devicetree/bindings/net/dsa/dsa.txt @@ -10,7 +10,7 @@ Required properties: - dsa,ethernet : Should be a phandle to a valid Ethernet device node - dsa,mii-bus : Should be a phandle to a valid MDIO bus device node -Optionnal properties: +Optional properties: - interrupts : property with a value describing the switch interrupt number (not supported by the driver) @@ -23,6 +23,13 @@ Each of these switch child nodes should have the following required properties: - #address-cells : Must be 1 - #size-cells : Must be 0 +A switch child node has the following optional property: + +- eeprom-length : Set to the length of an EEPROM connected to the + switch. Must be set if the switch can not detect + the presence and/or size of a connected EEPROM, + otherwise optional. + A switch may have multiple "port" children nodes Each port children node must have the following mandatory properties: diff --git a/Documentation/networking/bonding.txt b/Documentation/networking/bonding.txt index eeb5b2e97bed..83bf4986baea 100644 --- a/Documentation/networking/bonding.txt +++ b/Documentation/networking/bonding.txt @@ -2230,11 +2230,8 @@ balance-rr: This mode is the only mode that will permit a single It is possible to adjust TCP/IP's congestion limits by altering the net.ipv4.tcp_reordering sysctl parameter. The - usual default value is 3, and the maximum useful value is 127. - For a four interface balance-rr bond, expect that a single - TCP/IP stream will utilize no more than approximately 2.3 - interface's worth of throughput, even after adjusting - tcp_reordering. + usual default value is 3. But keep in mind TCP stack is able + to automatically increase this when it detects reorders. Note that the fraction of packets that will be delivered out of order is highly variable, and is unlikely to be zero. The level diff --git a/Documentation/networking/ip-sysctl.txt b/Documentation/networking/ip-sysctl.txt index a476b08a43e0..9bffdfc648dc 100644 --- a/Documentation/networking/ip-sysctl.txt +++ b/Documentation/networking/ip-sysctl.txt @@ -383,9 +383,17 @@ tcp_orphan_retries - INTEGER may consume significant resources. Cf. tcp_max_orphans. tcp_reordering - INTEGER - Maximal reordering of packets in a TCP stream. + Initial reordering level of packets in a TCP stream. + TCP stack can then dynamically adjust flow reordering level + between this initial value and tcp_max_reordering Default: 3 +tcp_max_reordering - INTEGER + Maximal reordering level of packets in a TCP stream. + 300 is a fairly conservative value, but you might increase it + if paths are using per packet load balancing (like bonding rr mode) + Default: 300 + tcp_retrans_collapse - BOOLEAN Bug-to-bug compatibility with some broken printers. On retransmit try to send bigger packets to work around bugs in @@ -1466,6 +1474,19 @@ suppress_frag_ndisc - INTEGER 1 - (default) discard fragmented neighbor discovery packets 0 - allow fragmented neighbor discovery packets +optimistic_dad - BOOLEAN + Whether to perform Optimistic Duplicate Address Detection (RFC 4429). + 0: disabled (default) + 1: enabled + +use_optimistic - BOOLEAN + If enabled, do not classify optimistic addresses as deprecated during + source address selection. Preferred addresses will still be chosen + before optimistic addresses, subject to other ranking in the source + address selection algorithm. + 0: disabled (default) + 1: enabled + icmp/*: ratelimit - INTEGER Limit the maximal rates for sending ICMPv6 packets. |