diff options
Diffstat (limited to 'drivers/net/ethernet/qualcomm')
| -rw-r--r-- | drivers/net/ethernet/qualcomm/emac/emac-ethtool.c | 30 | ||||
| -rw-r--r-- | drivers/net/ethernet/qualcomm/emac/emac-mac.c | 25 | ||||
| -rw-r--r-- | drivers/net/ethernet/qualcomm/emac/emac.c | 3 | ||||
| -rw-r--r-- | drivers/net/ethernet/qualcomm/emac/emac.h | 3 | ||||
| -rw-r--r-- | drivers/net/ethernet/qualcomm/rmnet/rmnet_config.c | 5 |
5 files changed, 61 insertions, 5 deletions
diff --git a/drivers/net/ethernet/qualcomm/emac/emac-ethtool.c b/drivers/net/ethernet/qualcomm/emac/emac-ethtool.c index bbe24639aa5a..c8c6231b87f3 100644 --- a/drivers/net/ethernet/qualcomm/emac/emac-ethtool.c +++ b/drivers/net/ethernet/qualcomm/emac/emac-ethtool.c @@ -88,6 +88,8 @@ static void emac_set_msglevel(struct net_device *netdev, u32 data) static int emac_get_sset_count(struct net_device *netdev, int sset) { switch (sset) { + case ETH_SS_PRIV_FLAGS: + return 1; case ETH_SS_STATS: return EMAC_STATS_LEN; default: @@ -100,6 +102,10 @@ static void emac_get_strings(struct net_device *netdev, u32 stringset, u8 *data) unsigned int i; switch (stringset) { + case ETH_SS_PRIV_FLAGS: + strcpy(data, "single-pause-mode"); + break; + case ETH_SS_STATS: for (i = 0; i < EMAC_STATS_LEN; i++) { strlcpy(data, emac_ethtool_stat_strings[i], @@ -230,6 +236,27 @@ static int emac_get_regs_len(struct net_device *netdev) return EMAC_MAX_REG_SIZE * sizeof(u32); } +#define EMAC_PRIV_ENABLE_SINGLE_PAUSE BIT(0) + +static int emac_set_priv_flags(struct net_device *netdev, u32 flags) +{ + struct emac_adapter *adpt = netdev_priv(netdev); + + adpt->single_pause_mode = !!(flags & EMAC_PRIV_ENABLE_SINGLE_PAUSE); + + if (netif_running(netdev)) + return emac_reinit_locked(adpt); + + return 0; +} + +static u32 emac_get_priv_flags(struct net_device *netdev) +{ + struct emac_adapter *adpt = netdev_priv(netdev); + + return adpt->single_pause_mode ? EMAC_PRIV_ENABLE_SINGLE_PAUSE : 0; +} + static const struct ethtool_ops emac_ethtool_ops = { .get_link_ksettings = phy_ethtool_get_link_ksettings, .set_link_ksettings = phy_ethtool_set_link_ksettings, @@ -253,6 +280,9 @@ static const struct ethtool_ops emac_ethtool_ops = { .get_regs_len = emac_get_regs_len, .get_regs = emac_get_regs, + + .set_priv_flags = emac_set_priv_flags, + .get_priv_flags = emac_get_priv_flags, }; void emac_set_ethtool_ops(struct net_device *netdev) diff --git a/drivers/net/ethernet/qualcomm/emac/emac-mac.c b/drivers/net/ethernet/qualcomm/emac/emac-mac.c index bcd4708b3745..3ed9033e56db 100644 --- a/drivers/net/ethernet/qualcomm/emac/emac-mac.c +++ b/drivers/net/ethernet/qualcomm/emac/emac-mac.c @@ -551,6 +551,28 @@ static void emac_mac_start(struct emac_adapter *adpt) mac &= ~(HUGEN | VLAN_STRIP | TPAUSE | SIMR | HUGE | MULTI_ALL | DEBUG_MODE | SINGLE_PAUSE_MODE); + /* Enable single-pause-frame mode if requested. + * + * If enabled, the EMAC will send a single pause frame when the RX + * queue is full. This normally leads to packet loss because + * the pause frame disables the remote MAC only for 33ms (the quanta), + * and then the remote MAC continues sending packets even though + * the RX queue is still full. + * + * If disabled, the EMAC sends a pause frame every 31ms until the RX + * queue is no longer full. Normally, this is the preferred + * method of operation. However, when the system is hung (e.g. + * cores are halted), the EMAC interrupt handler is never called + * and so the RX queue fills up quickly and stays full. The resuling + * non-stop "flood" of pause frames sometimes has the effect of + * disabling nearby switches. In some cases, other nearby switches + * are also affected, shutting down the entire network. + * + * The user can enable or disable single-pause-frame mode + * via ethtool. + */ + mac |= adpt->single_pause_mode ? SINGLE_PAUSE_MODE : 0; + writel_relaxed(csr1, adpt->csr + EMAC_EMAC_WRAPPER_CSR1); writel_relaxed(mac, adpt->base + EMAC_MAC_CTRL); @@ -876,7 +898,8 @@ static void emac_mac_rx_descs_refill(struct emac_adapter *adpt, curr_rxbuf->dma_addr = dma_map_single(adpt->netdev->dev.parent, skb->data, - curr_rxbuf->length, DMA_FROM_DEVICE); + adpt->rxbuf_size, DMA_FROM_DEVICE); + ret = dma_mapping_error(adpt->netdev->dev.parent, curr_rxbuf->dma_addr); if (ret) { diff --git a/drivers/net/ethernet/qualcomm/emac/emac.c b/drivers/net/ethernet/qualcomm/emac/emac.c index 60850bfa3d32..759543512117 100644 --- a/drivers/net/ethernet/qualcomm/emac/emac.c +++ b/drivers/net/ethernet/qualcomm/emac/emac.c @@ -443,6 +443,9 @@ static void emac_init_adapter(struct emac_adapter *adpt) /* default to automatic flow control */ adpt->automatic = true; + + /* Disable single-pause-frame mode by default */ + adpt->single_pause_mode = false; } /* Get the clock */ diff --git a/drivers/net/ethernet/qualcomm/emac/emac.h b/drivers/net/ethernet/qualcomm/emac/emac.h index 8ee4ec6aef2e..d7c9f44209d4 100644 --- a/drivers/net/ethernet/qualcomm/emac/emac.h +++ b/drivers/net/ethernet/qualcomm/emac/emac.h @@ -363,6 +363,9 @@ struct emac_adapter { bool tx_flow_control; bool rx_flow_control; + /* True == use single-pause-frame mode. */ + bool single_pause_mode; + /* Ring parameter */ u8 tpd_burst; u8 rfd_burst; diff --git a/drivers/net/ethernet/qualcomm/rmnet/rmnet_config.c b/drivers/net/ethernet/qualcomm/rmnet/rmnet_config.c index 98f22551eb45..1e33aea59f50 100644 --- a/drivers/net/ethernet/qualcomm/rmnet/rmnet_config.c +++ b/drivers/net/ethernet/qualcomm/rmnet/rmnet_config.c @@ -51,10 +51,7 @@ struct rmnet_walk_data { static int rmnet_is_real_dev_registered(const struct net_device *real_dev) { - rx_handler_func_t *rx_handler; - - rx_handler = rcu_dereference(real_dev->rx_handler); - return (rx_handler == rmnet_rx_handler); + return rcu_access_pointer(real_dev->rx_handler) == rmnet_rx_handler; } /* Needs rtnl lock */ |