diff options
Diffstat (limited to 'drivers')
| -rw-r--r-- | drivers/spi/spi-cadence-quadspi.c | 21 | ||||
| -rw-r--r-- | drivers/spi/spi-imx.c | 18 | ||||
| -rw-r--r-- | drivers/spi/spi-meson-spicc.c | 2 | ||||
| -rw-r--r-- | drivers/spi/spi-mt65xx.c | 19 | ||||
| -rw-r--r-- | drivers/spi/spi-mux.c | 8 | ||||
| -rw-r--r-- | drivers/spi/spi.c | 4 |
6 files changed, 53 insertions, 19 deletions
diff --git a/drivers/spi/spi-cadence-quadspi.c b/drivers/spi/spi-cadence-quadspi.c index a2de23516553..101cc71bffa7 100644 --- a/drivers/spi/spi-cadence-quadspi.c +++ b/drivers/spi/spi-cadence-quadspi.c @@ -325,7 +325,15 @@ static int cqspi_set_protocol(struct cqspi_flash_pdata *f_pdata, f_pdata->inst_width = CQSPI_INST_TYPE_SINGLE; f_pdata->addr_width = CQSPI_INST_TYPE_SINGLE; f_pdata->data_width = CQSPI_INST_TYPE_SINGLE; - f_pdata->dtr = op->data.dtr && op->cmd.dtr && op->addr.dtr; + + /* + * For an op to be DTR, cmd phase along with every other non-empty + * phase should have dtr field set to 1. If an op phase has zero + * nbytes, ignore its dtr field; otherwise, check its dtr field. + */ + f_pdata->dtr = op->cmd.dtr && + (!op->addr.nbytes || op->addr.dtr) && + (!op->data.nbytes || op->data.dtr); switch (op->data.buswidth) { case 0: @@ -1228,8 +1236,15 @@ static bool cqspi_supports_mem_op(struct spi_mem *mem, { bool all_true, all_false; - all_true = op->cmd.dtr && op->addr.dtr && op->dummy.dtr && - op->data.dtr; + /* + * op->dummy.dtr is required for converting nbytes into ncycles. + * Also, don't check the dtr field of the op phase having zero nbytes. + */ + all_true = op->cmd.dtr && + (!op->addr.nbytes || op->addr.dtr) && + (!op->dummy.nbytes || op->dummy.dtr) && + (!op->data.nbytes || op->data.dtr); + all_false = !op->cmd.dtr && !op->addr.dtr && !op->dummy.dtr && !op->data.dtr; diff --git a/drivers/spi/spi-imx.c b/drivers/spi/spi-imx.c index 4aee3db6d6df..fa68e9817929 100644 --- a/drivers/spi/spi-imx.c +++ b/drivers/spi/spi-imx.c @@ -505,7 +505,9 @@ static int mx51_ecspi_prepare_message(struct spi_imx_data *spi_imx, struct spi_message *msg) { struct spi_device *spi = msg->spi; + struct spi_transfer *xfer; u32 ctrl = MX51_ECSPI_CTRL_ENABLE; + u32 min_speed_hz = ~0U; u32 testreg, delay; u32 cfg = readl(spi_imx->base + MX51_ECSPI_CONFIG); @@ -577,9 +579,21 @@ static int mx51_ecspi_prepare_message(struct spi_imx_data *spi_imx, * be asserted before the SCLK polarity changes, which would disrupt * the SPI communication as the device on the other end would consider * the change of SCLK polarity as a clock tick already. + * + * Because spi_imx->spi_bus_clk is only set in bitbang prepare_message + * callback, iterate over all the transfers in spi_message, find the + * one with lowest bus frequency, and use that bus frequency for the + * delay calculation. In case all transfers have speed_hz == 0, then + * min_speed_hz is ~0 and the resulting delay is zero. */ - delay = (2 * 1000000) / spi_imx->spi_bus_clk; - if (likely(delay < 10)) /* SCLK is faster than 100 kHz */ + list_for_each_entry(xfer, &msg->transfers, transfer_list) { + if (!xfer->speed_hz) + continue; + min_speed_hz = min(xfer->speed_hz, min_speed_hz); + } + + delay = (2 * 1000000) / min_speed_hz; + if (likely(delay < 10)) /* SCLK is faster than 200 kHz */ udelay(delay); else /* SCLK is _very_ slow */ usleep_range(delay, delay + 10); diff --git a/drivers/spi/spi-meson-spicc.c b/drivers/spi/spi-meson-spicc.c index b2c4621db34d..c208efeadd18 100644 --- a/drivers/spi/spi-meson-spicc.c +++ b/drivers/spi/spi-meson-spicc.c @@ -785,6 +785,8 @@ static int meson_spicc_remove(struct platform_device *pdev) clk_disable_unprepare(spicc->core); clk_disable_unprepare(spicc->pclk); + spi_master_put(spicc->master); + return 0; } diff --git a/drivers/spi/spi-mt65xx.c b/drivers/spi/spi-mt65xx.c index 68dca8ceb3ad..7914255521c3 100644 --- a/drivers/spi/spi-mt65xx.c +++ b/drivers/spi/spi-mt65xx.c @@ -426,24 +426,15 @@ static int mtk_spi_fifo_transfer(struct spi_master *master, mtk_spi_prepare_transfer(master, xfer); mtk_spi_setup_packet(master); - cnt = xfer->len / 4; - if (xfer->tx_buf) + if (xfer->tx_buf) { + cnt = xfer->len / 4; iowrite32_rep(mdata->base + SPI_TX_DATA_REG, xfer->tx_buf, cnt); - - if (xfer->rx_buf) - ioread32_rep(mdata->base + SPI_RX_DATA_REG, xfer->rx_buf, cnt); - - remainder = xfer->len % 4; - if (remainder > 0) { - reg_val = 0; - if (xfer->tx_buf) { + remainder = xfer->len % 4; + if (remainder > 0) { + reg_val = 0; memcpy(®_val, xfer->tx_buf + (cnt * 4), remainder); writel(reg_val, mdata->base + SPI_TX_DATA_REG); } - if (xfer->rx_buf) { - reg_val = readl(mdata->base + SPI_RX_DATA_REG); - memcpy(xfer->rx_buf + (cnt * 4), ®_val, remainder); - } } mtk_spi_enable_transfer(master); diff --git a/drivers/spi/spi-mux.c b/drivers/spi/spi-mux.c index 37dfc6e82804..9708b7827ff7 100644 --- a/drivers/spi/spi-mux.c +++ b/drivers/spi/spi-mux.c @@ -167,10 +167,17 @@ err_put_ctlr: return ret; } +static const struct spi_device_id spi_mux_id[] = { + { "spi-mux" }, + { } +}; +MODULE_DEVICE_TABLE(spi, spi_mux_id); + static const struct of_device_id spi_mux_of_match[] = { { .compatible = "spi-mux" }, { } }; +MODULE_DEVICE_TABLE(of, spi_mux_of_match); static struct spi_driver spi_mux_driver = { .probe = spi_mux_probe, @@ -178,6 +185,7 @@ static struct spi_driver spi_mux_driver = { .name = "spi-mux", .of_match_table = spi_mux_of_match, }, + .id_table = spi_mux_id, }; module_spi_driver(spi_mux_driver); diff --git a/drivers/spi/spi.c b/drivers/spi/spi.c index c99181165321..e4dc593b1f32 100644 --- a/drivers/spi/spi.c +++ b/drivers/spi/spi.c @@ -58,6 +58,10 @@ modalias_show(struct device *dev, struct device_attribute *a, char *buf) const struct spi_device *spi = to_spi_device(dev); int len; + len = of_device_modalias(dev, buf, PAGE_SIZE); + if (len != -ENODEV) + return len; + len = acpi_device_modalias(dev, buf, PAGE_SIZE - 1); if (len != -ENODEV) return len; |