diff options
Diffstat (limited to 'drivers')
| -rw-r--r-- | drivers/crypto/Kconfig | 23 | ||||
| -rw-r--r-- | drivers/crypto/qce/skcipher.c | 20 |
2 files changed, 35 insertions, 8 deletions
diff --git a/drivers/crypto/Kconfig b/drivers/crypto/Kconfig index c2767ed54dfe..052d3ff7fb20 100644 --- a/drivers/crypto/Kconfig +++ b/drivers/crypto/Kconfig @@ -685,6 +685,29 @@ choice endchoice +config CRYPTO_DEV_QCE_SW_MAX_LEN + int "Default maximum request size to use software for AES" + depends on CRYPTO_DEV_QCE && CRYPTO_DEV_QCE_SKCIPHER + default 512 + help + This sets the default maximum request size to perform AES requests + using software instead of the crypto engine. It can be changed by + setting the aes_sw_max_len parameter. + + Small blocks are processed faster in software than hardware. + Considering the 256-bit ciphers, software is 2-3 times faster than + qce at 256-bytes, 30% faster at 512, and about even at 768-bytes. + With 128-bit keys, the break-even point would be around 1024-bytes. + + The default is set a little lower, to 512 bytes, to balance the + cost in CPU usage. The minimum recommended setting is 16-bytes + (1 AES block), since AES-GCM will fail if you set it lower. + Setting this to zero will send all requests to the hardware. + + Note that 192-bit keys are not supported by the hardware and are + always processed by the software fallback, and all DES requests + are done by the hardware. + config CRYPTO_DEV_QCOM_RNG tristate "Qualcomm Random Number Generator Driver" depends on ARCH_QCOM || COMPILE_TEST diff --git a/drivers/crypto/qce/skcipher.c b/drivers/crypto/qce/skcipher.c index 63ae75809cb7..fc7c940b5a43 100644 --- a/drivers/crypto/qce/skcipher.c +++ b/drivers/crypto/qce/skcipher.c @@ -5,6 +5,7 @@ #include <linux/device.h> #include <linux/interrupt.h> +#include <linux/moduleparam.h> #include <linux/types.h> #include <crypto/aes.h> #include <crypto/internal/des.h> @@ -12,6 +13,13 @@ #include "cipher.h" +static unsigned int aes_sw_max_len = CONFIG_CRYPTO_DEV_QCE_SW_MAX_LEN; +module_param(aes_sw_max_len, uint, 0644); +MODULE_PARM_DESC(aes_sw_max_len, + "Only use hardware for AES requests larger than this " + "[0=always use hardware; anything <16 breaks AES-GCM; default=" + __stringify(CONFIG_CRYPTO_DEV_QCE_SOFT_THRESHOLD)"]"); + static LIST_HEAD(skcipher_algs); static void qce_skcipher_done(void *data) @@ -166,15 +174,10 @@ static int qce_skcipher_setkey(struct crypto_skcipher *ablk, const u8 *key, switch (IS_XTS(flags) ? keylen >> 1 : keylen) { case AES_KEYSIZE_128: case AES_KEYSIZE_256: + memcpy(ctx->enc_key, key, keylen); break; - default: - goto fallback; } - ctx->enc_keylen = keylen; - memcpy(ctx->enc_key, key, keylen); - return 0; -fallback: ret = crypto_sync_skcipher_setkey(ctx->fallback, key, keylen); if (!ret) ctx->enc_keylen = keylen; @@ -224,8 +227,9 @@ static int qce_skcipher_crypt(struct skcipher_request *req, int encrypt) rctx->flags |= encrypt ? QCE_ENCRYPT : QCE_DECRYPT; keylen = IS_XTS(rctx->flags) ? ctx->enc_keylen >> 1 : ctx->enc_keylen; - if (IS_AES(rctx->flags) && keylen != AES_KEYSIZE_128 && - keylen != AES_KEYSIZE_256) { + if (IS_AES(rctx->flags) && + ((keylen != AES_KEYSIZE_128 && keylen != AES_KEYSIZE_256) || + req->cryptlen <= aes_sw_max_len)) { SYNC_SKCIPHER_REQUEST_ON_STACK(subreq, ctx->fallback); skcipher_request_set_sync_tfm(subreq, ctx->fallback); |