aboutsummaryrefslogtreecommitdiff
path: root/drivers
AgeCommit message (Expand)Author
2016-01-04i2c: imx: Remove unneeded commentsFabio Estevam
2016-01-03i2c: st: use to_platform_device()Geliang Tang
2016-01-03i2c: designware: use to_pci_dev()Geliang Tang
2016-01-03i2c: brcmstb: Adding support for CM and DSL SoCsKamal Dasu
2016-01-03i2c: mediatek: fix i2c multi transfer issue in high speed modeLiguo Zhang
2016-01-03i2c: imx: improve code readabilityGao Pan
2016-01-03i2c: imx: Improve message log when DMA is not usedFabio Estevam
2016-01-03i2c: imx: add runtime pm support to improve the performanceGao Pan
2016-01-03i2c: imx: init bus recovery info before adding i2c adapterGao Pan
2016-01-02i2c: rcar: disable PM in multi-master modeWolfram Sang
2016-01-02i2c: rcar: remove macros dealing with flagsWolfram Sang
2016-01-02i2c: img-scb: support repeated starts on IP v3.3Sifan Naeem
2016-01-02i2c: img-scb: add handle for Master halt interruptSifan Naeem
2016-01-02i2c: img-scb: add handle for stop detected interruptSifan Naeem
2016-01-02i2c: img-scb: remove fifo EMPTYING interrupts handleSifan Naeem
2016-01-02i2c: img-scb: support I2C_M_IGNORE_NAKSifan Naeem
2015-12-17i2c: make i2c_parse_fw_timings() always visibleWolfram Sang
2015-12-17i2c: emev: select I2C slave supportWolfram Sang
2015-12-16i2c: xlr: add interrupt support for Sigma Designs chipsMåns Rullgård
2015-12-16i2c: xlr: fix extra read/write at end of rx transferMåns Rullgård
2015-12-15i2c: xlr: add support for Sigma Designs controller variantMåns Rullgård
2015-12-14i2c: uniphier_f: error out if bus speed is zeroMasahiro Yamada
2015-12-14i2c: uniphier_f: error out if clock rate is zeroMasahiro Yamada
2015-12-14i2c: uniphier: error out if bus speed is zeroMasahiro Yamada
2015-12-14i2c: uniphier: error out if clock rate is zeroMasahiro Yamada
2015-12-14i2c: rcar: honor additional i2c timings from DTWolfram Sang
2015-12-14i2c: rcar: switch to i2c generic dt parsingWolfram Sang
2015-12-14i2c: rcar: refactor probe function a littleWolfram Sang
2015-12-14i2c: add generic routine to parse DT for timing informationWolfram Sang
2015-12-05i2c: emev2: add slave supportNiklas Söderlund
2015-12-03i2c: eg20t: allow build on MIPS platformsPaul Burton
2015-12-03i2c: eg20t: set i2c_adapter->dev.of_nodePaul Burton
2015-12-03i2c: at91: add support for the HOLD fieldLudovic Desroches
2015-12-03i2c: piix4: remove unneeded assignmentsWolfram Sang
2015-12-01i2c: mediatek: add i2c first write then read optimizationLiguo Zhang
2015-11-30i2c: cadence: Remove the suspended flagShubhrajyoti Datta
2015-11-30i2c: cadence: Move to sensible power managementShubhrajyoti Datta
2015-11-30i2c: bcm2835: add I2C_AQ_NO_CLK_STRETCHNicola Corna
2015-11-30i2c: algo-bit: add I2C_AQ_NO_CLK_STRETCHNicola Corna
2015-11-30i2c: xiic: Replace spinlock with mutexLars-Peter Clausen
2015-11-30i2c: taos-evm: replace simple_strtoul by kstrtou8LABBE Corentin
2015-11-30i2c: piix4: Add adapter port name support for SB800 chipsetChristian Fetzer
2015-11-30i2c: piix4: Add support for multiplexed main adapter in SB800Christian Fetzer
2015-11-30i2c: piix4: Convert piix4_main_adapter to arrayChristian Fetzer
2015-11-30i2c: rcar: handle difference in setting up non-first messageWolfram Sang
2015-11-30i2c: rcar: clean up after refactoringWolfram Sang
2015-11-30i2c: rcar: revoke START request earlyWolfram Sang
2015-11-30i2c: rcar: check master irqs before slave irqsWolfram Sang
2015-11-30i2c: rcar: don't issue stop when HW does it automaticallyWolfram Sang
2015-11-30i2c: rcar: init new messages in irqWolfram Sang
generated by cgit v1.2.3 (git 2.39.1) at 2024-12-18 10:11:38 +0000