| Age | Commit message (Collapse) | Author |
|---|
|
SOF topologies hard-code the MCLK used for SSP connections. That was a
bad idea in hindsight, this information should really come from BIOS
and/or machine driver.
This patch introduces a helper to scan all SSP endpoints connected to
a codec, and all formats to see what MCLK is used. When BIT(0) of the
mdivc offset if set in the SSP blob, MCLK0 is used, and likewise when
BIT(1) is set MCLK1 is used.
The case where both MCLKs are used is possible but has never been seen
in practice so should be treated as an error by the caller.
Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Reviewed-by: Kai Vehmanen <kai.vehmanen@linux.intel.com>
Reviewed-by: Bard Liao <yung-chuan.liao@linux.intel.com>
Reviewed-by: Takashi Iwai <tiwai@suse.de>
Link: https://lore.kernel.org/r/20220919115350.43104-4-pierre-louis.bossart@linux.intel.com
Signed-off-by: Mark Brown <broonie@kernel.org>
|
|
As functions prototypes regerdless of CONFIG options as well as some
code depend on structures defined in sound/intel-nhlt.h header, move
them out of #define block. This allows to compile code depending on
mentioned header with "depends on ACPI || COMPILE_TEST" in Kconfig.
Fixes: 47a1886a610a ("ASoC: Intel: avs: Enable AVS driver only on x86 platforms")
Reported-by: kernel test robot <lkp@intel.com>
Suggested-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Reviewed-by: Cezary Rojewski <cezary.rojewski@intel.com>
Signed-off-by: Amadeusz Sławiński <amadeuszx.slawinski@linux.intel.com>
Link: https://lore.kernel.org/r/20220426200539.894010-1-amadeuszx.slawinski@linux.intel.com
Signed-off-by: Mark Brown <broonie@kernel.org>
|
|
The NHLT information can be used to figure out which SSPs are enabled
in a platform.
The 'SSP' link type is too broad for machine drivers, since it can
cover the Bluetooth sideband and the analog audio codec connections,
so this helper exposes a parameter to filter with the device
type (DEVICE_I2S refers to analog audio codec in NHLT parlance).
The helper returns a mask, since more than one SSP may be used for
analog audio, e.g. the NHLT spec describes the use of SSP0 for
amplifiers and SSP1 for headset codec. Note that if more than one bit
is set, it's impossible to determine which SSP is connected to what
external component. Additional platform-specific information based on
e.g. DMI quirks would still be required in the machine driver to
configure the relevant dailinks.
Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Reviewed-by: Bard Liao <yung-chuan.liao@linux.intel.com>
Reviewed-by: Péter Ujfalusi <peter.ujfalusi@linux.intel.com>
Acked-by: Takashi Iwai <tiwai@suse.de>
Link: https://lore.kernel.org/r/20220308192610.392950-5-pierre-louis.bossart@linux.intel.com
Signed-off-by: Mark Brown <broonie@kernel.org>
|
|
Two key operations missings are: endpoint presence-check and retrieval
of matching endpoint hardware configuration (blob). Add operations for
both use cases.
Signed-off-by: Amadeusz Sławiński <amadeuszx.slawinski@linux.intel.com>
Signed-off-by: Cezary Rojewski <cezary.rojewski@intel.com>
Link: https://lore.kernel.org/r/20211126140355.1042684-2-cezary.rojewski@intel.com
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
Multiple bug reports report issues with the SOF and SST drivers when
dealing with single microphone cases.
We currently read the DMIC array information unconditionally but we
don't check that the configuration type is actually a mic array.
When the DMIC link does not rely on a mic array configuration, the
recommendation is to check the format information to infer the maximum
number of channels, and map this to the number of microphones.
This leaves a potential for a mismatch between actual microphones
available in hardware and what the ACPI table contains, but we have no
other source of information.
Note that single microphone configurations can alternatively be
handled with a 'mic array' configuration along with a 'vendor-defined'
geometry.
Bugzilla: https://bugzilla.kernel.org/show_bug.cgi?id=201251
BugLink: https://github.com/thesofproject/linux/issues/2725
Fixes: 7a33ea70e1868 ('ALSA: hda: intel-nhlt: handle NHLT VENDOR_DEFINED DMIC geometry')
Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Reviewed-by: Guennadi Liakhovetski <guennadi.liakhovetski@intel.com>
Reviewed-by: Rander Wang <rander.wang@intel.com>
Reviewed-by: Kai Vehmanen <kai.vehmanen@linux.intel.com>
Link: https://lore.kernel.org/r/20210302000146.1177770-1-pierre-louis.bossart@linux.intel.com
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
The current codebase makes use of the zero-length array language
extension to the C90 standard, but the preferred mechanism to declare
variable-length types such as these ones is a flexible array member[1][2],
introduced in C99:
struct foo {
int stuff;
struct boo array[];
};
By making use of the mechanism above, we will get a compiler warning
in case the flexible array does not occur last in the structure, which
will help us prevent some kind of undefined behavior bugs from being
inadvertently introduced[3] to the codebase from now on.
Also, notice that, dynamic memory allocations won't be affected by
this change:
"Flexible array members have incomplete type, and so the sizeof operator
may not be applied. As a quirk of the original implementation of
zero-length arrays, sizeof evaluates to zero."[1]
sizeof(flexible-array-member) triggers a warning because flexible array
members have incomplete type[1]. There are some instances of code in
which the sizeof operator is being incorrectly/erroneously applied to
zero-length arrays and the result is zero. Such instances may be hiding
some bugs. So, this work (flexible-array member conversions) will also
help to get completely rid of those sorts of issues.
This issue was found with the help of Coccinelle.
[1] https://gcc.gnu.org/onlinedocs/gcc/Zero-Length.html
[2] https://github.com/KSPP/linux/issues/21
[3] commit 76497732932f ("cxgb3/l2t: Fix undefined behaviour")
Signed-off-by: Gustavo A. R. Silva <gustavoars@kernel.org>
Link: https://lore.kernel.org/r/20200507192223.GA16335@embeddedor
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
The NHLT spec defines a VENDOR_DEFINED geometry, which requires
reading additional information to figure out the number of
microphones.
Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
Move parts of the code outside of the Skylake driver to help detect
the presence of DMICs (which are not supported by the HDaudio legacy
driver).
No functionality change (except for the removal of useless OR
operations), only indentation and checkpatch fixes, making sure
that the code compiles without ACPI and fixing an ACPI leak
Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
Prepare move from NHLT code to common directory, starting with header.
Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
