From 53b774718f784d614c8bfed20a3b32fb753604f3 Mon Sep 17 00:00:00 2001 From: Bruce Duncan Date: Thu, 25 Aug 2022 15:01:41 +0200 Subject: docs: i2c: piix4: Fix typos, add markup, drop link [JD: Update the subject One more typo fixed Drop the link to lm-sensors' README, it's irrelevant] Signed-off-by: Bruce Duncan Reviewed-by: Jean Delvare Signed-off-by: Wolfram Sang --- Documentation/i2c/busses/i2c-piix4.rst | 13 +++++-------- 1 file changed, 5 insertions(+), 8 deletions(-) (limited to 'Documentation/i2c') diff --git a/Documentation/i2c/busses/i2c-piix4.rst b/Documentation/i2c/busses/i2c-piix4.rst index cc9000259223..07fe6f6f4b18 100644 --- a/Documentation/i2c/busses/i2c-piix4.rst +++ b/Documentation/i2c/busses/i2c-piix4.rst @@ -64,7 +64,7 @@ correct address for this module, you could get in big trouble (read: crashes, data corruption, etc.). Try this only as a last resort (try BIOS updates first, for example), and backup first! An even more dangerous option is 'force_addr='. This will not only enable the PIIX4 like -'force' foes, but it will also set a new base I/O port address. The SMBus +'force' does, but it will also set a new base I/O port address. The SMBus parts of the PIIX4 needs a range of 8 of these addresses to function correctly. If these addresses are already reserved by some other device, you will get into big trouble! DON'T USE THIS IF YOU ARE NOT VERY SURE @@ -86,15 +86,15 @@ If you own Force CPCI735 motherboard or other OSB4 based systems you may need to change the SMBus Interrupt Select register so the SMBus controller uses the SMI mode. -1) Use lspci command and locate the PCI device with the SMBus controller: +1) Use ``lspci`` command and locate the PCI device with the SMBus controller: 00:0f.0 ISA bridge: ServerWorks OSB4 South Bridge (rev 4f) The line may vary for different chipsets. Please consult the driver source - for all possible PCI ids (and lspci -n to match them). Lets assume the + for all possible PCI ids (and ``lspci -n`` to match them). Let's assume the device is located at 00:0f.0. 2) Now you just need to change the value in 0xD2 register. Get it first with - command: lspci -xxx -s 00:0f.0 + command: ``lspci -xxx -s 00:0f.0`` If the value is 0x3 then you need to change it to 0x1: - setpci -s 00:0f.0 d2.b=1 + ``setpci -s 00:0f.0 d2.b=1`` Please note that you don't need to do that in all cases, just when the SMBus is not working properly. @@ -109,6 +109,3 @@ which can easily get corrupted due to a state machine bug. These are mostly Thinkpad laptops, but desktop systems may also be affected. We have no list of all affected systems, so the only safe solution was to prevent access to the SMBus on all IBM systems (detected using DMI data.) - -For additional information, read: -http://www.lm-sensors.org/browser/lm-sensors/trunk/README -- cgit v1.2.3