From 3a5395b3d57b9e3836c755434c88f4590d5ea6f6 Mon Sep 17 00:00:00 2001 From: Jens Renner \(EFE\) Date: Mon, 3 Jun 2013 04:32:52 +0000 Subject: net: ethernet: xilinx_emaclite: set protocol selector bits when writing ANAR This patch sets the protocol selector bits (4:0) of the PHY's MII_ADVERTISE register (ANAR) when writing ADVERTISE_ALL. The protocol selector bits are indicating IEEE 803.3u support and are fixed / read-only on some PHYs. Not setting them correctly on others (like TI DP83630) makes the PHY fall back to 10M HDX mode which should be avoided. Tested for TI DP83630 PHY on Microblaze platform. Signed-off-by: Jens Renner Tested-by: Michal Simek Signed-off-by: David S. Miller --- drivers/net/ethernet/xilinx/xilinx_emaclite.c | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-) (limited to 'drivers/net') diff --git a/drivers/net/ethernet/xilinx/xilinx_emaclite.c b/drivers/net/ethernet/xilinx/xilinx_emaclite.c index 919b983114e9..b7268b3dae77 100644 --- a/drivers/net/ethernet/xilinx/xilinx_emaclite.c +++ b/drivers/net/ethernet/xilinx/xilinx_emaclite.c @@ -946,7 +946,8 @@ static int xemaclite_open(struct net_device *dev) phy_write(lp->phy_dev, MII_CTRL1000, 0); /* Advertise only 10 and 100mbps full/half duplex speeds */ - phy_write(lp->phy_dev, MII_ADVERTISE, ADVERTISE_ALL); + phy_write(lp->phy_dev, MII_ADVERTISE, ADVERTISE_ALL | + ADVERTISE_CSMA); /* Restart auto negotiation */ bmcr = phy_read(lp->phy_dev, MII_BMCR); -- cgit v1.2.3