From 643bae17fd4ccb503cdc6d99c1b4fbd2c4ca6a78 Mon Sep 17 00:00:00 2001 From: Steve Douthit Date: Thu, 6 Dec 2018 15:50:43 +0000 Subject: ixgbe: use mii_bus to handle MII related ioctls Use the mii_bus callbacks to address the entire clause 22/45 address space. Enables userspace to poke switch registers instead of a single PHY address. The ixgbe firmware may be polling PHYs in a way that is not protected by the mii_bus lock. This isn't new behavior, but as Andrew Lunn pointed out there are more addresses available for conflicts. Signed-off-by: Stephen Douthit Reviewed-by: Andrew Lunn Reviewed-by: Florian Fainelli Tested-by: Andrew Bowers Signed-off-by: Jeff Kirsher --- drivers/net/ethernet/intel/ixgbe/ixgbe_main.c | 18 ++++++++++++++++++ 1 file changed, 18 insertions(+) (limited to 'drivers/net') diff --git a/drivers/net/ethernet/intel/ixgbe/ixgbe_main.c b/drivers/net/ethernet/intel/ixgbe/ixgbe_main.c index 7a3798ff2366..daff8183534b 100644 --- a/drivers/net/ethernet/intel/ixgbe/ixgbe_main.c +++ b/drivers/net/ethernet/intel/ixgbe/ixgbe_main.c @@ -8791,6 +8791,15 @@ ixgbe_mdio_read(struct net_device *netdev, int prtad, int devad, u16 addr) u16 value; int rc; + if (adapter->mii_bus) { + int regnum = addr; + + if (devad != MDIO_DEVAD_NONE) + regnum |= (devad << 16) | MII_ADDR_C45; + + return mdiobus_read(adapter->mii_bus, prtad, regnum); + } + if (prtad != hw->phy.mdio.prtad) return -EINVAL; rc = hw->phy.ops.read_reg(hw, addr, devad, &value); @@ -8805,6 +8814,15 @@ static int ixgbe_mdio_write(struct net_device *netdev, int prtad, int devad, struct ixgbe_adapter *adapter = netdev_priv(netdev); struct ixgbe_hw *hw = &adapter->hw; + if (adapter->mii_bus) { + int regnum = addr; + + if (devad != MDIO_DEVAD_NONE) + regnum |= (devad << 16) | MII_ADDR_C45; + + return mdiobus_write(adapter->mii_bus, prtad, regnum, value); + } + if (prtad != hw->phy.mdio.prtad) return -EINVAL; return hw->phy.ops.write_reg(hw, addr, devad, value); -- cgit v1.2.3