From 4e6a13356f1c1dc27ff48ff35576a478d73f8713 Mon Sep 17 00:00:00 2001 From: Lukas Wunner Date: Sat, 28 Jul 2018 07:22:00 +0200 Subject: PCI: pciehp: Deduplicate presence check on probe & resume On driver probe and on resume from system sleep, pciehp checks the Presence Detect State bit in the Slot Status register to bring up an occupied slot or bring down an unoccupied slot. Both code paths are identical, so deduplicate them per Mika's request. On probe, an additional check is performed to disable power of an unoccupied slot. This can e.g. happen if power was enabled by BIOS. It cannot happen once pciehp has taken control, hence is not necessary on resume: The Slot Control register is set to the same value that it had on suspend by pci_restore_state(), so if the slot was occupied, power is enabled and if it wasn't, power is disabled. Should occupancy have changed during the system sleep transition, power is adjusted by bringing up or down the slot per the paragraph above. To allow for deduplication of the presence check, move the power check to pcie_init(). This seems safer anyway, because right now it is performed while interrupts are already enabled, and although I can't think of a scenario where pciehp_power_off_slot() and the IRQ thread collide, it does feel brittle. However this means that pcie_init() may now write to the Slot Control register before the IRQ is requested. If both the CCIE and HPIE bits happen to be set, pcie_wait_cmd() will wait for an interrupt (instead of polling the Command Completed bit) and eventually emit a timeout message. Additionally, if a level-triggered INTx interrupt is used, the user may see a spurious interrupt splat. Avoid by disabling interrupts before disabling power. (Normally the HPIE and CCIE bits should be clear on probe, but conceivably they may already have been set e.g. by BIOS.) Signed-off-by: Lukas Wunner Signed-off-by: Bjorn Helgaas Reviewed-by: Mika Westerberg --- drivers/pci/hotplug/pciehp_hpc.c | 14 ++++++++++++++ 1 file changed, 14 insertions(+) (limited to 'drivers/pci/hotplug/pciehp_hpc.c') diff --git a/drivers/pci/hotplug/pciehp_hpc.c b/drivers/pci/hotplug/pciehp_hpc.c index 6f7de0819c88..5b15e76f3564 100644 --- a/drivers/pci/hotplug/pciehp_hpc.c +++ b/drivers/pci/hotplug/pciehp_hpc.c @@ -856,6 +856,7 @@ struct controller *pcie_init(struct pcie_device *dev) { struct controller *ctrl; u32 slot_cap, link_cap; + u8 occupied, poweron; struct pci_dev *pdev = dev->port; ctrl = kzalloc(sizeof(*ctrl), GFP_KERNEL); @@ -910,6 +911,19 @@ struct controller *pcie_init(struct pcie_device *dev) if (pcie_init_slot(ctrl)) goto abort_ctrl; + /* + * If empty slot's power status is on, turn power off. The IRQ isn't + * requested yet, so avoid triggering a notification with this command. + */ + if (POWER_CTRL(ctrl)) { + pciehp_get_adapter_status(ctrl->slot, &occupied); + pciehp_get_power_status(ctrl->slot, &poweron); + if (!occupied && poweron) { + pcie_disable_notification(ctrl); + pciehp_power_off_slot(ctrl->slot); + } + } + return ctrl; abort_ctrl: -- cgit v1.2.3