From e8405f0f617856de0ceb7d04e65b663051451544 Mon Sep 17 00:00:00 2001 From: Dominik Brodowski Date: Thu, 29 Jul 2010 15:50:55 +0200 Subject: pcmcia: move Vpp setup to struct pcmcia_device Some drivers prefer to explicitly set Vpp. Instead of passing the voltage inside config_req_t, store it in struct pcmcia_device. CC: linux-ide@vger.kernel.org CC: netdev@vger.kernel.org CC: linux-mtd@lists.infradead.org CC: linux-wireless@vger.kernel.org CC: linux-serial@vger.kernel.org CC: linux-usb@vger.kernel.org CC: linux-scsi@vger.kernel.org Acked-by: Gustavo F. Padovan (for drivers/bluetooth) Tested-by: Wolfram Sang Signed-off-by: Dominik Brodowski --- drivers/scsi/pcmcia/nsp_cs.c | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-) (limited to 'drivers/scsi/pcmcia') diff --git a/drivers/scsi/pcmcia/nsp_cs.c b/drivers/scsi/pcmcia/nsp_cs.c index e872e0684273..50574e869418 100644 --- a/drivers/scsi/pcmcia/nsp_cs.c +++ b/drivers/scsi/pcmcia/nsp_cs.c @@ -1624,10 +1624,10 @@ static int nsp_cs_config_check(struct pcmcia_device *p_dev, } if (cfg->vpp1.present & (1 << CISTPL_POWER_VNOM)) { - p_dev->conf.Vpp = + p_dev->vpp = cfg->vpp1.param[CISTPL_POWER_VNOM] / 10000; } else if (dflt->vpp1.present & (1 << CISTPL_POWER_VNOM)) { - p_dev->conf.Vpp = + p_dev->vpp = dflt->vpp1.param[CISTPL_POWER_VNOM] / 10000; } @@ -1749,8 +1749,8 @@ static int nsp_cs_config(struct pcmcia_device *link) /* Finally, report what we've done */ printk(KERN_INFO "nsp_cs: index 0x%02x: ", link->conf.ConfigIndex); - if (link->conf.Vpp) { - printk(", Vpp %d.%d", link->conf.Vpp/10, link->conf.Vpp%10); + if (link->vpp) { + printk(", Vpp %d.%d", link->vpp/10, link->vpp%10); } if (link->conf.Attributes & CONF_ENABLE_IRQ) { printk(", irq %d", link->irq); -- cgit v1.2.3