From 656a7c2b1210deddf76444ecc76e058c0404ce80 Mon Sep 17 00:00:00 2001 From: Hauke Mehrtens Date: Fri, 20 Dec 2013 02:16:12 +0100 Subject: b44: do not set PHY address to 30 for every ext PHY b44_phy_reset() will fail for an external PHY and only work with the internal PHY, this was an old workaround when the detection of an external switch based on the PHY address failed and it is not needed any more. Signed-off-by: Hauke Mehrtens Signed-off-by: David S. Miller --- drivers/net/ethernet/broadcom/b44.c | 7 +++++-- 1 file changed, 5 insertions(+), 2 deletions(-) (limited to 'drivers') diff --git a/drivers/net/ethernet/broadcom/b44.c b/drivers/net/ethernet/broadcom/b44.c index d17561bd7ca0..839dd9092b17 100644 --- a/drivers/net/ethernet/broadcom/b44.c +++ b/drivers/net/ethernet/broadcom/b44.c @@ -2412,8 +2412,11 @@ static int b44_init_one(struct ssb_device *sdev, b44_chip_reset(bp, B44_CHIP_RESET_FULL); /* do a phy reset to test if there is an active phy */ - if (b44_phy_reset(bp) < 0) - bp->phy_addr = B44_PHY_ADDR_NO_LOCAL_PHY; + err = b44_phy_reset(bp); + if (err < 0) { + dev_err(sdev->dev, "phy reset failed\n"); + goto err_out_unregister_netdev; + } if (bp->flags & B44_FLAG_EXTERNAL_PHY) { err = b44_register_phy_one(bp); -- cgit v1.2.3