From 6d190c6edf42a572485cf1b6c7479bfc42753084 Mon Sep 17 00:00:00 2001 From: Ron Mercer Date: Wed, 28 Oct 2009 08:39:20 +0000 Subject: qlge: Fix EEH handling. Clean up driver resources without touch the hardware. Add pci save/restore state. Signed-off-by: Ron Mercer Signed-off-by: David S. Miller --- drivers/net/qlge/qlge_main.c | 78 +++++++++++++++++++++++++++++--------------- 1 file changed, 52 insertions(+), 26 deletions(-) (limited to 'drivers') diff --git a/drivers/net/qlge/qlge_main.c b/drivers/net/qlge/qlge_main.c index 48b45df85ec9..cea7531f4f40 100644 --- a/drivers/net/qlge/qlge_main.c +++ b/drivers/net/qlge/qlge_main.c @@ -3916,6 +3916,7 @@ static int __devinit ql_init_device(struct pci_dev *pdev, goto err_out; } + pci_save_state(pdev); qdev->reg_base = ioremap_nocache(pci_resource_start(pdev, 1), pci_resource_len(pdev, 1)); @@ -4070,6 +4071,33 @@ static void __devexit qlge_remove(struct pci_dev *pdev) free_netdev(ndev); } +/* Clean up resources without touching hardware. */ +static void ql_eeh_close(struct net_device *ndev) +{ + int i; + struct ql_adapter *qdev = netdev_priv(ndev); + + if (netif_carrier_ok(ndev)) { + netif_carrier_off(ndev); + netif_stop_queue(ndev); + } + + if (test_bit(QL_ADAPTER_UP, &qdev->flags)) + cancel_delayed_work_sync(&qdev->asic_reset_work); + cancel_delayed_work_sync(&qdev->mpi_reset_work); + cancel_delayed_work_sync(&qdev->mpi_work); + cancel_delayed_work_sync(&qdev->mpi_idc_work); + cancel_delayed_work_sync(&qdev->mpi_port_cfg_work); + + for (i = 0; i < qdev->rss_ring_count; i++) + netif_napi_del(&qdev->rx_ring[i].napi); + + clear_bit(QL_ADAPTER_UP, &qdev->flags); + ql_tx_ring_clean(qdev); + ql_free_rx_buffers(qdev); + ql_release_adapter_resources(qdev); +} + /* * This callback is called by the PCI subsystem whenever * a PCI bus error is detected. @@ -4078,17 +4106,21 @@ static pci_ers_result_t qlge_io_error_detected(struct pci_dev *pdev, enum pci_channel_state state) { struct net_device *ndev = pci_get_drvdata(pdev); - struct ql_adapter *qdev = netdev_priv(ndev); - - netif_device_detach(ndev); - if (state == pci_channel_io_perm_failure) + switch (state) { + case pci_channel_io_normal: + return PCI_ERS_RESULT_CAN_RECOVER; + case pci_channel_io_frozen: + netif_device_detach(ndev); + if (netif_running(ndev)) + ql_eeh_close(ndev); + pci_disable_device(pdev); + return PCI_ERS_RESULT_NEED_RESET; + case pci_channel_io_perm_failure: + dev_err(&pdev->dev, + "%s: pci_channel_io_perm_failure.\n", __func__); return PCI_ERS_RESULT_DISCONNECT; - - if (netif_running(ndev)) - ql_adapter_down(qdev); - - pci_disable_device(pdev); + } /* Request a slot reset. */ return PCI_ERS_RESULT_NEED_RESET; @@ -4105,25 +4137,15 @@ static pci_ers_result_t qlge_io_slot_reset(struct pci_dev *pdev) struct net_device *ndev = pci_get_drvdata(pdev); struct ql_adapter *qdev = netdev_priv(ndev); + pdev->error_state = pci_channel_io_normal; + + pci_restore_state(pdev); if (pci_enable_device(pdev)) { QPRINTK(qdev, IFUP, ERR, "Cannot re-enable PCI device after reset.\n"); return PCI_ERS_RESULT_DISCONNECT; } - pci_set_master(pdev); - - netif_carrier_off(ndev); - ql_adapter_reset(qdev); - - /* Make sure the EEPROM is good */ - memcpy(ndev->perm_addr, ndev->dev_addr, ndev->addr_len); - - if (!is_valid_ether_addr(ndev->perm_addr)) { - QPRINTK(qdev, IFUP, ERR, "After reset, invalid MAC address.\n"); - return PCI_ERS_RESULT_DISCONNECT; - } - return PCI_ERS_RESULT_RECOVERED; } @@ -4131,17 +4153,21 @@ static void qlge_io_resume(struct pci_dev *pdev) { struct net_device *ndev = pci_get_drvdata(pdev); struct ql_adapter *qdev = netdev_priv(ndev); + int err = 0; - pci_set_master(pdev); - + if (ql_adapter_reset(qdev)) + QPRINTK(qdev, DRV, ERR, "reset FAILED!\n"); if (netif_running(ndev)) { - if (ql_adapter_up(qdev)) { + err = qlge_open(ndev); + if (err) { QPRINTK(qdev, IFUP, ERR, "Device initialization failed after reset.\n"); return; } + } else { + QPRINTK(qdev, IFUP, ERR, + "Device was not running prior to EEH.\n"); } - netif_device_attach(ndev); } -- cgit v1.2.3