blob: 6bd3f2e93d61d9818bda71c6c328c407b082a884 (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
|
* Freescale low power universal asynchronous receiver/transmitter (lpuart)
Required properties:
- compatible :
- "fsl,vf610-lpuart" for lpuart compatible with the one integrated
on Vybrid vf610 SoC with 8-bit register organization
- "fsl,ls1021a-lpuart" for lpuart compatible with the one integrated
on LS1021A SoC with 32-bit big-endian register organization
- "fsl,imx7ulp-lpuart" for lpuart compatible with the one integrated
on i.MX7ULP SoC with 32-bit little-endian register organization
- reg : Address and length of the register set for the device
- interrupts : Should contain uart interrupt
- clocks : phandle + clock specifier pairs, one for each entry in clock-names
- clock-names : should contain: "ipg" - the uart clock
Optional properties:
- dmas: A list of two dma specifiers, one for each entry in dma-names.
- dma-names: should contain "tx" and "rx".
- rs485-rts-delay, rs485-rts-active-low, rs485-rx-during-tx,
linux,rs485-enabled-at-boot-time: see rs485.txt
Note: Optional properties for DMA support. Write them both or both not.
Example:
uart0: serial@40027000 {
compatible = "fsl,vf610-lpuart";
reg = <0x40027000 0x1000>;
interrupts = <0 61 0x00>;
clocks = <&clks VF610_CLK_UART0>;
clock-names = "ipg";
dmas = <&edma0 0 2>,
<&edma0 0 3>;
dma-names = "rx","tx";
};
|
