diff options
Diffstat (limited to 'Documentation/networking/stmmac.txt')
| -rw-r--r-- | Documentation/networking/stmmac.txt | 45 |
1 files changed, 39 insertions, 6 deletions
diff --git a/Documentation/networking/stmmac.txt b/Documentation/networking/stmmac.txt index f9fa6db40a52..654d2e55c8cb 100644 --- a/Documentation/networking/stmmac.txt +++ b/Documentation/networking/stmmac.txt @@ -1,6 +1,6 @@ STMicroelectronics 10/100/1000 Synopsys Ethernet driver -Copyright (C) 2007-2010 STMicroelectronics Ltd +Copyright (C) 2007-2013 STMicroelectronics Ltd Author: Giuseppe Cavallaro <peppe.cavallaro@st.com> This is the driver for the MAC 10/100/1000 on-chip Ethernet controllers @@ -10,7 +10,7 @@ Currently this network device driver is for all STM embedded MAC/GMAC (i.e. 7xxx/5xxx SoCs), SPEAr (arm), Loongson1B (mips) and XLINX XC2V3000 FF1152AMT0221 D1215994A VIRTEX FPGA board. -DWC Ether MAC 10/100/1000 Universal version 3.60a (and older) and DWC Ether +DWC Ether MAC 10/100/1000 Universal version 3.70a (and older) and DWC Ether MAC 10/100 Universal version 4.0 have been used for developing this driver. This driver supports both the platform bus and PCI. @@ -32,6 +32,8 @@ The kernel configuration option is STMMAC_ETH: watchdog: transmit timeout (in milliseconds); flow_ctrl: Flow control ability [on/off]; pause: Flow Control Pause Time; + eee_timer: tx EEE timer; + chain_mode: select chain mode instead of ring. 3) Command line options Driver parameters can be also passed in command line by using: @@ -164,12 +166,12 @@ Where: o bus_setup: perform HW setup of the bus. For example, on some ST platforms this field is used to configure the AMBA bridge to generate more efficient STBus traffic. - o init/exit: callbacks used for calling a custom initialisation; + o init/exit: callbacks used for calling a custom initialization; this is sometime necessary on some platforms (e.g. ST boxes) where the HW needs to have set some PIO lines or system cfg registers. o custom_cfg/custom_data: this is a custom configuration that can be passed - while initialising the resources. + while initializing the resources. o bsp_priv: another private poiter. For MDIO bus The we have: @@ -273,6 +275,8 @@ reset procedure etc). o norm_desc.c: functions for handling normal descriptors; o chain_mode.c/ring_mode.c:: functions to manage RING/CHAINED modes; o mmc_core.c/mmc.h: Management MAC Counters; + o stmmac_hwtstamp.c: HW timestamp support for PTP + o stmmac_ptp.c: PTP 1588 clock 5) Debug Information @@ -326,6 +330,35 @@ To enter in Tx LPI mode the driver needs to have a software timer that enable and disable the LPI mode when there is nothing to be transmitted. -7) TODO: +7) Extended descriptors +The extended descriptors give us information about the receive Ethernet payload +when it is carrying PTP packets or TCP/UDP/ICMP over IP. +These are not available on GMAC Synopsys chips older than the 3.50. +At probe time the driver will decide if these can be actually used. +This support also is mandatory for PTPv2 because the extra descriptors 6 and 7 +are used for saving the hardware timestamps. + +8) Precision Time Protocol (PTP) +The driver supports the IEEE 1588-2002, Precision Time Protocol (PTP), +which enables precise synchronization of clocks in measurement and +control systems implemented with technologies such as network +communication. + +In addition to the basic timestamp features mentioned in IEEE 1588-2002 +Timestamps, new GMAC cores support the advanced timestamp features. +IEEE 1588-2008 that can be enabled when configure the Kernel. + +9) SGMII/RGMII supports +New GMAC devices provide own way to manage RGMII/SGMII. +This information is available at run-time by looking at the +HW capability register. This means that the stmmac can manage +auto-negotiation and link status w/o using the PHYLIB stuff +In fact, the HW provides a subset of extended registers to +restart the ANE, verify Full/Half duplex mode and Speed. +Also thanks to these registers it is possible to look at the +Auto-negotiated Link Parter Ability. + +10) TODO: o XGMAC is not supported. - o Add the PTP - precision time protocol + o Complete the TBI & RTBI support. + o extened VLAN support for 3.70a SYNP GMAC. |