reset: Remove addr parameter from reset_cpu()

Historically, the reset_cpu() function had an `addr` parameter which was
meant to pass in an address of the reset vector location, where the CPU
should reset to.  This feature is no longer used anywhere in U-Boot as
all reset_cpu() implementations now ignore the passed value.  Generic
code has been added which always calls reset_cpu() with `0` which means
this feature can no longer be used easily anyway.

Over time, many implementations seem to have "misunderstood" the
existence of this parameter as a way to customize/parameterize the reset
(e.g.  COLD vs WARM resets).  As this is not properly supported, the
code will almost always not do what it is intended to (because all
call-sites just call reset_cpu() with 0).

To avoid confusion and to clean up the codebase from unused left-overs
of the past, remove the `addr` parameter entirely.  Code which intends
to support different kinds of resets should be rewritten as a sysreset
driver instead.

This transformation was done with the following coccinelle patch:

    @@
    expression argvalue;
    @@
    - reset_cpu(argvalue)
    + reset_cpu()

    @@
    identifier argname;
    type argtype;
    @@
    - reset_cpu(argtype argname)
    + reset_cpu(void)
    { ... }

Signed-off-by: Harald Seiler <hws@denx.de>
Reviewed-by: Simon Glass <sjg@chromium.org>

1 files changed, 1 insertions, 1 deletions

diff --git a/board/highbank/highbank.c b/board/highbank/highbank.c
index a790d453da0..906bd9b6dda 100644
--- a/board/highbank/highbank.c
+++ b/board/highbank/highbank.c
@@ -128,7 +128,7 @@ static int is_highbank(void)
 	return (midr & 0xfff0) == 0xc090;
 }
 
-void reset_cpu(ulong addr)
+void reset_cpu(void)
 {
 	writel(HB_PWR_HARD_RESET, HB_SREG_A9_PWR_REQ);
 	if (is_highbank())