ARM: DT: stm32f7: add sdram pin contol node

Also added DT binding doc for stm32 fmc(flexible memory controller).

Signed-off-by: Vikas Manocha <vikas.manocha@st.com>
cc: Christophe KERELLO <christophe.kerello@st.com>

1 files changed, 51 insertions, 0 deletions

diff --git a/doc/device-tree-bindings/ram/st,stm32-fmc.txt b/doc/device-tree-bindings/ram/st,stm32-fmc.txt
new file mode 100644
index 00000000000..3d1392c7640
--- /dev/null
+++ b/doc/device-tree-bindings/ram/st,stm32-fmc.txt
@@ -0,0 +1,51 @@
+ST, stm32 flexible memory controller Drive
+Required properties:
+- compatible	: "st,stm32-fmc"
+- reg		: fmc controller base address
+- clocks	: fmc controller clock
+u-boot,dm-pre-reloc: flag to initialize memory before relocation.
+
+on-board sdram memory attributes:
+- st,sdram-control : parameters for sdram configuration, in this order:
+  number of columns
+  number of rows
+  memory width
+  number of intenal banks in memory
+  cas latency
+  read burst enable or disable
+  read pipe delay
+
+- st,sdram-timing: timings for sdram, in this order:
+  tmrd
+  txsr
+  tras
+  trc
+  trp
+  trcd
+
+There is device tree include file at :
+include/dt-bindings/memory/stm32-sdram.h to define sdram control and timing
+parameters as MACROS.
+
+Example:
+	fmc: fmc@A0000000 {
+	     compatible = "st,stm32-fmc";
+	     reg = <0xA0000000 0x1000>;
+	     clocks = <&rcc 0 64>;
+	     u-boot,dm-pre-reloc;
+	};
+
+	&fmc {
+		pinctrl-0 = <&fmc_pins>;
+		pinctrl-names = "default";
+		status = "okay";
+
+		mr-nbanks = <1>;
+		/* sdram memory configuration from sdram datasheet */
+	bank1: bank@0 {
+	       st,sdram-control = /bits/ 8 <NO_COL_8 NO_ROW_12 MWIDTH_16 BANKS_2
+						CAS_3 RD_BURST_EN RD_PIPE_DL_0>;
+	       st,sdram-timing = /bits/ 8 <TMRD_1 TXSR_60 TRAS_42 TRC_60 TRP_18
+						TRCD_18>;
+       };
+}