arm: Remove unused ST-Ericsson u8500 arch

This arch does not seem to be supported / used at all in the current
U-Boot mainline source tree any more. So lets remove the core u8500 code
and code that was only referenced by this platform.

Please note that this patch also removes these config options:

- CONFIG_PL011_SERIAL_RLCR
- CONFIG_PL011_SERIAL_FLUSH_ON_INIT

As they only seem to be referenced by u8500 based boards. Without any
such board in the current code, these config option don't make sense
any more. Lets remove them as well.

If someone still wants to use this platform, then please send patches
to re-enable support by adding at least one board that references this
code.

Signed-off-by: Stefan Roese <sr@denx.de>
Cc: Mathieu Poirier <mathieu.poirier@linaro.org>
Cc: John Rigby <john.rigby@linaro.org>
Cc: Simon Glass <sjg@chromium.org>
Cc: Masahiro Yamada <yamada.masahiro@socionext.com>
Cc: Tom Rini <trini@konsulko.com>
Cc: Heiko Schocher <hs@denx.de>
Cc: Albert Aribaud <albert.u.boot@aribaud.net>
Reviewed-by: Masahiro Yamada <yamada.masahiro@socionext.com>

1 files changed, 0 insertions, 22 deletions

diff --git a/drivers/serial/serial_pl01x.c b/drivers/serial/serial_pl01x.c
index ecf3bc02409..3a5c1d0eaab 100644
--- a/drivers/serial/serial_pl01x.c
+++ b/drivers/serial/serial_pl01x.c
@@ -80,13 +80,6 @@ static int pl01x_generic_serial_init(struct pl01x_regs *regs,
 		writel(0, &regs->pl010_cr);
 		break;
 	case TYPE_PL011:
-#ifdef CONFIG_PL011_SERIAL_FLUSH_ON_INIT
-		/* Empty RX fifo if necessary */
-		if (readl(&regs->pl011_cr) & UART_PL011_CR_UARTEN) {
-			while (!(readl(&regs->fr) & UART_PL01x_FR_RXFE))
-				readl(&regs->dr);
-		}
-#endif
 		/* disable everything */
 		writel(0, &regs->pl011_cr);
 		break;
@@ -105,21 +98,6 @@ static int pl011_set_line_control(struct pl01x_regs *regs)
 	 * control register write
 	 */
 	lcr = UART_PL011_LCRH_WLEN_8 | UART_PL011_LCRH_FEN;
-#ifdef CONFIG_PL011_SERIAL_RLCR
-	{
-		int i;
-
-		/*
-		 * Program receive line control register after waiting
-		 * 10 bus cycles.  Delay be writing to readonly register
-		 * 10 times
-		 */
-		for (i = 0; i < 10; i++)
-			writel(lcr, &regs->fr);
-
-		writel(lcr, &regs->pl011_rlcr);
-	}
-#endif
 	writel(lcr, &regs->pl011_lcrh);
 	return 0;
 }