u-boot.git - U-Boot bootloader

Age	Commit message (Expand)	Author
2019-10-25	net: mt7628-eth: add support to isolate LAN/WAN ports	Weijie Gao
2019-10-25	net: mt7628-eth: free rx descriptor on receiving failure	Weijie Gao
2019-10-25	net: mt7628-eth: make phy link up detection optional via DT	Weijie Gao
2019-10-25	net: mt7628-eth: remove hardcoded gpio settings and regmap-based phy reset	Weijie Gao
2019-10-25	phy: mt76x8-usb-phy: add slew rate calibration and remove non-mt7628 part	Weijie Gao
2019-10-25	dts: mtmips: update reset controller node for mt7628	Weijie Gao
2019-10-25	reset: add reset controller driver for MediaTek MIPS platform	Weijie Gao
2019-10-25	dts: mtmips: add default pinctrl for uart nodes	Weijie Gao
2019-10-25	dts: mtmips: add pinctrl node for mt7628	Weijie Gao
2019-10-25	pinctrl: add support for MediaTek MT7628	Weijie Gao
2019-10-25	spi: mt7621-spi: restore default register value after each xfer	Weijie Gao
2019-10-25	spi: mt7621-spi: remove data cache and rewrite its xfer function	Weijie Gao
2019-10-25	spi: mt7621-spi: use clock frequency from clk driver	Weijie Gao
2019-10-25	dts: mtmips: add clock node for mt7628	Weijie Gao
2019-10-25	clk: add clock driver for MediaTek MT76x8 platform	Weijie Gao
2019-10-25	dts: mtmips: enable high-speed UART support for mt7628	Weijie Gao
2019-10-25	dts: mtmips: move uart property clock-frequency into mt7628an.dtsi	Weijie Gao
2019-10-25	serial: serial_mtk: add non-DM version for SPL	Weijie Gao
2019-10-25	serial: serial_mtk: enable FIFO and disable flow control	Weijie Gao
2019-10-25	drivers: nand: brcmnand: fix nand_chip ecc layout structure	William Zhang
2019-10-25	mips: bmips: switch to board defines for dtb	Álvaro Fernández Rojas
2019-10-25	bmips: correct name characters	Álvaro Fernández Rojas
2019-10-25	bmips: configs: switch to size definitions	Álvaro Fernández Rojas
2019-10-25	mips: bmips: remove unneeded definitions	Álvaro Fernández Rojas
2019-10-25	bmips: enable vr-3032u nand support	Álvaro Fernández Rojas
2019-10-25	bmips: bcm63268: add support for brcmnand	Álvaro Fernández Rojas
2019-10-25	bmips: bcm6362: add support for brcmnand	Álvaro Fernández Rojas
2019-10-25	bmips: bcm6328: add support for brcmnand	Álvaro Fernández Rojas
2019-10-25	bmips: bcm6368: add support for brcmnand	Álvaro Fernández Rojas
2019-10-25	nand: brcm: add BCM6368 support	Álvaro Fernández Rojas
2019-10-25	MIPS: add compile time definition of L2 cache size	Ramon Fried
2019-10-24	Merge branch '2019-10-24-UFS-support'	Tom Rini
2019-10-24	Merge https://gitlab.denx.de/u-boot/custodians/u-boot-marvell	Tom Rini
2019-10-24	configs: j721e_evm_a72_defconfig: Add HBMC related configs	Vignesh Raghavendra
2019-10-24	configs: j721e_evm.h: Define CONFIG_SYS_MAX_FLASH_BANKS_DETECT	Vignesh Raghavendra
2019-10-24	arm: dts: k3-j721e-som-p0: Add HyperFlash node	Vignesh Raghavendra
2019-10-24	arm: dts: k3-j721e-mcu-wakeup: Add HyperBus Controller node	Vignesh Raghavendra
2019-10-24	mtd: Add TI HyperBus Memory Controller driver	Vignesh Raghavendra
2019-10-24	mtd: cfi_flash: Use CONFIG_SYS_MONITOR_BASE only when defined	Vignesh Raghavendra
2019-10-23	configs: j721e_evm_a72: Enable configs for UFS	Faiz Abbas
2019-10-23	env: ti: Add environment variables to boot from UFS	Faiz Abbas
2019-10-23	cmd: Add Support for UFS commands	Faiz Abbas
2019-10-23	arm: dts: k3-j721e-main: Add UFS nodes	Faiz Abbas
2019-10-23	ufs: Add glue layer driver for TI J721E devices	Faiz Abbas
2019-10-23	ufs: Add Support for Cadence platform UFS driver	Faiz Abbas
2019-10-23	ufs: Add Initial Support for UFS subsystem	Faiz Abbas
2019-10-23	scsi: Add dma direction member to command structure	Faiz Abbas
2019-10-23	scsi: Retry inquiry 3 times to overcome Unit Attention condition	Faiz Abbas
2019-10-23	scsi: Add max_bytes_per_req to scsi_platdata	Faiz Abbas
2019-10-23	scsi: Simplify scsi_read()/_write()	Faiz Abbas