From 72573543b5b9f788b46fb9e7ab3372cfeba8d25f Mon Sep 17 00:00:00 2001 From: Stephen Warren Date: Fri, 2 Nov 2012 06:56:13 +0000 Subject: ARM: tegra: enable 8-bit SD slots in board files Harmony contains an SD slot with all 8 bits routed. This allows plugging in an eMMC-chip-in-SD-form-factor. Seaboard/Springbank/Ventana/AC100 all have an eMMC chip with all 8 bits hooked up. Now that the U-Boot eMMC code fully supports 8-bit operation, initialize those ports as 8-bit instead of 4-bit to improve performance. Whistler was already registering its ports as 8-bit. TrimSlice doesn't have any 8-bit ports. I don't have any Avionic Design boards nor the Colibri board to test with. Signed-off-by: Stephen Warren Signed-off-by: Tom Warren --- board/compal/paz00/paz00.c | 5 ++--- 1 file changed, 2 insertions(+), 3 deletions(-) (limited to 'board/compal/paz00') diff --git a/board/compal/paz00/paz00.c b/board/compal/paz00/paz00.c index 0725989de06..6492d4168e1 100644 --- a/board/compal/paz00/paz00.c +++ b/board/compal/paz00/paz00.c @@ -61,9 +61,8 @@ int board_mmc_init(bd_t *bd) pin_mux_mmc(); debug("board_mmc_init: init eMMC\n"); - /* init dev 0, eMMC chip, with 4-bit bus */ - /* The board has an 8-bit bus, but 8-bit doesn't work yet */ - tegra_mmc_init(0, 4, -1, -1); + /* init dev 0, eMMC chip, with 8-bit bus */ + tegra_mmc_init(0, 8, -1, -1); debug("board_mmc_init: init SD slot\n"); /* init dev 3, SD slot, with 4-bit bus */ -- cgit v1.2.3