From e88edc7b4affa764d33fc5a356fd8c15d33356e3 Mon Sep 17 00:00:00 2001 From: Jagan Teki Date: Sat, 8 Oct 2016 18:00:19 +0530 Subject: arm: imx6q: Add devicetree support for Engicam i.CoreM6 DualLite/Solo i.CoreM6 DualLite/Solo modules are system on module solutions manufactured by Engicam with following characteristics: CPU NXP i.MX6 DL, 800MHz RAM 1GB, 32, 64 bit, DDR3-800/1066 NAND SLC,512MB Power supply Single 5V MAX LCD RES FULLHD and more info at http://www.engicam.com/en/products/embedded/som/sodimm/i-core-m6s-dl-d-q Cc: Peng Fan Cc: Stefano Babic Cc: Fabio Estevam Cc: Matteo Lisi Cc: Michael Trimarchi Signed-off-by: Jagan Teki --- board/engicam/icorem6/README | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-) (limited to 'board/engicam') diff --git a/board/engicam/icorem6/README b/board/engicam/icorem6/README index cf2eff2da4c..c264a9443b4 100644 --- a/board/engicam/icorem6/README +++ b/board/engicam/icorem6/README @@ -7,15 +7,15 @@ $ make mrproper $ make icorem6qdl_mmc_defconfig $ make -This will generate the SPL image called SPL and the u-boot.img. +This will generate the SPL image called SPL and the u-boot-dtb.img. - Flash the SPL image into the micro SD card: sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync -- Flash the u-boot.img image into the micro SD card: +- Flash the u-boot-dtb.img image into the micro SD card: -sudo dd if=u-boot.img of=/dev/mmcblk0 bs=1k seek=69; sync +sudo dd if=u-boot-dtb.img of=/dev/mmcblk0 bs=1k seek=69; sync - Jumper settings: -- cgit v1.2.3