From 25484d907039148807e9b1c4924c816f59a13929 Mon Sep 17 00:00:00 2001 From: T Karthik Reddy Date: Fri, 2 Apr 2021 01:49:17 -0600 Subject: xilinx: common: Fix boot script address Currently u-boot supports addresses upto 39-bits only. If anybody wants to use addresses of more than 39-bits in Linux they will have a separate memory node in DT. In such cases they will have multiple memory nodes. Currently u-boot selects and runs on lower memory bank region. But bootscript is being loaded on dram bank 0, where dram bank 0 will point to 1st memory node in DT. If first memory node is mentioned as higher ddr(>39-bits address) then u-boot cannot load the bootscript. So fix this issue by setting bootscript address within the lower memory bank region. Signed-off-by: T Karthik Reddy Signed-off-by: Ashok Reddy Soma Signed-off-by: Michal Simek --- board/xilinx/common/board.c | 6 ++---- 1 file changed, 2 insertions(+), 4 deletions(-) (limited to 'board/xilinx') diff --git a/board/xilinx/common/board.c b/board/xilinx/common/board.c index 475628b9254..92b61d83ca4 100644 --- a/board/xilinx/common/board.c +++ b/board/xilinx/common/board.c @@ -378,14 +378,12 @@ int board_late_init_xilinx(void) int i, id, macid = 0; struct xilinx_board_description *desc; phys_size_t bootm_size = gd->ram_size; - struct bd_info *bd = gd->bd; - if (!CONFIG_IS_ENABLED(MICROBLAZE) && bd->bi_dram[0].start) { + if (!CONFIG_IS_ENABLED(MICROBLAZE)) { ulong scriptaddr; scriptaddr = env_get_hex("scriptaddr", 0); - ret |= env_set_hex("scriptaddr", - bd->bi_dram[0].start + scriptaddr); + ret |= env_set_hex("scriptaddr", gd->ram_base + scriptaddr); } if (CONFIG_IS_ENABLED(ARCH_ZYNQ) || CONFIG_IS_ENABLED(MICROBLAZE)) -- cgit v1.2.3