From b9b342eaec7cf3c9d7836bc2bb302b26fd48af50 Mon Sep 17 00:00:00 2001 From: Cooper Jr., Franklin Date: Fri, 16 Jun 2017 17:25:23 -0500 Subject: ARM: k2g: Add pinmux support for K2G ICE evm Add basic pinmux data for new K2G ICE evm. Also add pinmuxing for a generic K2G evm which includes I2C 0 and 1 used for board detection purposes. Since multiple K2G boards are supported that means initially generic pinmuxing should be used when board detection hasn't ran. Once board detection runs the proper pinmuxing can be reran to match the board being ran on. Signed-off-by: Franklin S Cooper Jr Reviewed-by: Tom Rini --- board/ti/ks2_evm/board_k2g.c | 2 ++ board/ti/ks2_evm/mux-k2g.h | 45 +++++++++++++++++++++++++++++++++++++++++++- 2 files changed, 46 insertions(+), 1 deletion(-) (limited to 'board') diff --git a/board/ti/ks2_evm/board_k2g.c b/board/ti/ks2_evm/board_k2g.c index b4765f7939f..362231286bd 100644 --- a/board/ti/ks2_evm/board_k2g.c +++ b/board/ti/ks2_evm/board_k2g.c @@ -274,6 +274,8 @@ int embedded_dtb_select(void) fdtdec_setup(); + k2g_mux_config(); + k2g_reset_mux_config(); /* deassert FLASH_HOLD */ diff --git a/board/ti/ks2_evm/mux-k2g.h b/board/ti/ks2_evm/mux-k2g.h index 773f9b7f0ca..630103d0ff4 100644 --- a/board/ti/ks2_evm/mux-k2g.h +++ b/board/ti/ks2_evm/mux-k2g.h @@ -11,6 +11,22 @@ #include #include #include +#include "board.h" + +struct pin_cfg k2g_generic_pin_cfg[] = { + /* UART0 */ + { 115, MODE(0) }, /* SOC_UART0_RXD */ + { 116, MODE(0) }, /* SOC_UART0_TXD */ + + /* I2C 0 */ + { 223, MODE(0) }, /* SOC_I2C0_SCL */ + { 224, MODE(0) }, /* SOC_I2C0_SDA */ + + /* I2C 1 */ + { 225, MODE(0) }, /* SOC_I2C1_SCL */ + { 226, MODE(0) }, /* SOC_I2C1_SDA */ + { MAX_PIN_N, } +}; struct pin_cfg k2g_evm_pin_cfg[] = { /* GPMC */ @@ -307,7 +323,34 @@ struct pin_cfg k2g_evm_pin_cfg[] = { { MAX_PIN_N, } }; +struct pin_cfg k2g_ice_evm_pin_cfg[] = { + /* MMC 1 */ + { 63, MODE(0) | PIN_PTD }, /* MMC1_DAT3.MMC1_DAT3 */ + { 64, MODE(0) | PIN_PTU }, /* MMC1_DAT2.MMC1_DAT2 */ + { 65, MODE(0) | PIN_PTU }, /* MMC1_DAT1.MMC1_DAT1 */ + { 66, MODE(0) | PIN_PTD }, /* MMC1_DAT0.MMC1_DAT0 */ + { 67, MODE(0) | PIN_PTD }, /* MMC1_CLK.MMC1_CLK */ + { 68, MODE(0) | PIN_PTD }, /* MMC1_CMD.MMC1_CMD */ + { 69, MODE(3) | PIN_PTU }, /* MMC1_SDCD.GPIO0_69 */ + { 70, MODE(0) | PIN_PTU }, /* MMC1_SDWP.MMC1_SDWP */ + { 71, MODE(0) | PIN_PTD }, /* MMC1_POW.MMC1_POW */ + + /* I2C 0 */ + { 223, MODE(0) }, /* SOC_I2C0_SCL */ + { 224, MODE(0) }, /* SOC_I2C0_SDA */ + { MAX_PIN_N, } +}; + void k2g_mux_config(void) { - configure_pin_mux(k2g_evm_pin_cfg); + if (!board_ti_was_eeprom_read()) { + configure_pin_mux(k2g_generic_pin_cfg); + } else if (board_is_k2g_gp()) { + configure_pin_mux(k2g_evm_pin_cfg); + } else if (board_is_k2g_ice()) { + configure_pin_mux(k2g_ice_evm_pin_cfg); + } else { + puts("Unknown board, cannot configure pinmux."); + hang(); + } } -- cgit v1.2.3