From 1da426919dedc2ece25e05f5d8ca131142c7348c Mon Sep 17 00:00:00 2001 From: Patrick Delaunay Date: Thu, 21 Jan 2021 17:39:07 +0100 Subject: pinctrl: stm32: correct management pin display of OTYPE OTYPE can be used for output or for alternate function to select PP = push-pull or OP = open-drain mode, according reference manual (Table 81. Port bit configuration table). This patch removes this indication for input pins and adds it for AF and output pins for pinmux command output. Fixes: b305dbc08b08 ("pinctrl: stm32: display bias information for all pins") Signed-off-by: Patrick Delaunay Reviewed-by: Patrice Chotard --- drivers/pinctrl/pinctrl_stm32.c | 18 ++++++++---------- 1 file changed, 8 insertions(+), 10 deletions(-) (limited to 'drivers') diff --git a/drivers/pinctrl/pinctrl_stm32.c b/drivers/pinctrl/pinctrl_stm32.c index a1f53a793b4..374f76d881d 100644 --- a/drivers/pinctrl/pinctrl_stm32.c +++ b/drivers/pinctrl/pinctrl_stm32.c @@ -56,7 +56,7 @@ static const char * const pinmux_bias[] = { [STM32_GPIO_PUPD_DOWN] = "pull-down", }; -static const char * const pinmux_input[] = { +static const char * const pinmux_otype[] = { [STM32_GPIO_OTYPE_PP] = "push-pull", [STM32_GPIO_OTYPE_OD] = "open-drain", }; @@ -216,7 +216,7 @@ static int stm32_pinctrl_get_pin_muxing(struct udevice *dev, selector, gpio_idx, mode); priv = dev_get_priv(gpio_dev); pupd = (readl(&priv->regs->pupdr) >> (gpio_idx * 2)) & PUPD_MASK; - + otype = (readl(&priv->regs->otyper) >> gpio_idx) & OTYPE_MSK; switch (mode) { case GPIOF_UNKNOWN: @@ -227,18 +227,16 @@ static int stm32_pinctrl_get_pin_muxing(struct udevice *dev, break; case GPIOF_FUNC: af_num = stm32_pinctrl_get_af(gpio_dev, gpio_idx); - snprintf(buf, size, "%s %d %s", pinmux_mode[mode], af_num, - pinmux_bias[pupd]); + snprintf(buf, size, "%s %d %s %s", pinmux_mode[mode], af_num, + pinmux_otype[otype], pinmux_bias[pupd]); break; case GPIOF_OUTPUT: - snprintf(buf, size, "%s %s %s", - pinmux_mode[mode], pinmux_bias[pupd], - label ? label : ""); + snprintf(buf, size, "%s %s %s %s", + pinmux_mode[mode], pinmux_otype[otype], + pinmux_bias[pupd], label ? label : ""); break; case GPIOF_INPUT: - otype = (readl(&priv->regs->otyper) >> gpio_idx) & OTYPE_MSK; - snprintf(buf, size, "%s %s %s %s", - pinmux_mode[mode], pinmux_input[otype], + snprintf(buf, size, "%s %s %s", pinmux_mode[mode], pinmux_bias[pupd], label ? label : ""); break; } -- cgit v1.2.3