// SPDX-License-Identifier: GPL-2.0+ /* * Copyright (C) 2016 Stefan Roese */ #include #include #include #include #include #include /* Write the RBF data to FPGA via SPI */ static int program_write(int spi_bus, int spi_dev, const void *rbf_data, unsigned long rbf_size) { struct spi_slave *slave; int ret; debug("%s (%d): data=%p size=%ld\n", __func__, __LINE__, rbf_data, rbf_size); /* FIXME: How to get the max. SPI clock and SPI mode? */ slave = spi_setup_slave(spi_bus, spi_dev, 27777777, SPI_MODE_3); if (!slave) return -1; if (spi_claim_bus(slave)) return -1; ret = spi_xfer(slave, rbf_size * 8, rbf_data, (void *)rbf_data, SPI_XFER_BEGIN | SPI_XFER_END); spi_release_bus(slave); return ret; } /* * This is the interface used by FPGA driver. * Return 0 for sucess, non-zero for error. */ int stratixv_load(Altera_desc *desc, const void *rbf_data, size_t rbf_size) { altera_board_specific_func *pfns = desc->iface_fns; int cookie = desc->cookie; int spi_bus; int spi_dev; int ret = 0; if ((u32)rbf_data & 0x3) { puts("FPGA: Unaligned data, realign to 32bit boundary.\n"); return -EINVAL; } /* Run the pre configuration function if there is one */ if (pfns->pre) (pfns->pre)(cookie); /* Establish the initial state */ if (pfns->config) { /* De-assert nCONFIG */ (pfns->config)(false, true, cookie); /* nConfig minimum low pulse width is 2us */ udelay(200); /* Assert nCONFIG */ (pfns->config)(true, true, cookie); /* nCONFIG high to first rising clock on DCLK min 1506 us */ udelay(1600); } /* Write the RBF data to FPGA */ if (pfns->write) { /* * Use board specific data function to write bitstream * into the FPGA */ ret = (pfns->write)(rbf_data, rbf_size, true, cookie); } else { /* * Use common SPI functions to write bitstream into the * FPGA */ spi_bus = COOKIE2SPI_BUS(cookie); spi_dev = COOKIE2SPI_DEV(cookie); ret = program_write(spi_bus, spi_dev, rbf_data, rbf_size); } if (ret) return ret; /* Check done pin */ if (pfns->done) { ret = (pfns->done)(cookie); if (ret) printf("Error: DONE not set (ret=%d)!\n", ret); } return ret; }