integrator: do not test first part of the memory

When booting from Flash, the Integrator remaps its flash memory
from 0x24000000 to 0x00000000, and starts executing it at
0x00000000. This ROM thus hides the RAM underneath and first
0x40000 bytes of the memory cannot be tested by get_ram_size().
So let's test from 0x40000 to the end of detected memory
instead.

Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

1 files changed, 15 insertions, 4 deletions

diff --git a/board/armltd/integrator/integrator.c b/board/armltd/integrator/integrator.c
index c8d2bc7bacb..83f047c93eb 100644
--- a/board/armltd/integrator/integrator.c
+++ b/board/armltd/integrator/integrator.c
@@ -86,6 +86,15 @@ int misc_init_r (void)
 	return (0);
 }
 
+/*
+ * The Integrator remaps the Flash memory to 0x00000000 and executes U-Boot
+ * from there, which means we cannot test the RAM underneath the ROM at this
+ * point. It will be unmapped later on, when we are executing from the
+ * relocated in RAM U-Boot. We simply assume that this RAM is usable if the
+ * RAM on higher addresses works fine.
+ */
+#define REMAPPED_FLASH_SZ 0x40000
+
 int dram_init (void)
 {
 	gd->bd->bi_dram[0].start = CONFIG_SYS_SDRAM_BASE;
@@ -111,15 +120,17 @@ extern void dram_query(void);
 	 *
 	 */
 	sdram_shift		 = ((cm_reg_sdram & 0x0000001C)/4)%4;
-	gd->bd->bi_dram[0].size	 = 0x01000000 << sdram_shift;
-	gd->ram_size = get_ram_size((long *)CONFIG_SYS_SDRAM_BASE,
+	gd->ram_size = get_ram_size((long *) CONFIG_SYS_SDRAM_BASE +
+				    REMAPPED_FLASH_SZ,
 				    0x01000000 << sdram_shift);
 	}
 #else
-	gd->bd->bi_dram[0].size = PHYS_SDRAM_1_SIZE;
-	gd->ram_size = get_ram_size((long *)CONFIG_SYS_SDRAM_BASE,
+	gd->ram_size = get_ram_size((long *) CONFIG_SYS_SDRAM_BASE +
+				    REMAPPED_FLASH_SZ,
 				    PHYS_SDRAM_1_SIZE);
 #endif /* CM_SPD_DETECT */
+	/* We only have one bank of RAM, set it to whatever was detected */
+	gd->bd->bi_dram[0].size	 = gd->ram_size;
 
 	return 0;
 }