* Code cleanup

* Patch by Sascha Hauer, 28 Jun:
  - add generic support for Motorola i.MX architecture
  - add support for mx1ads, mx1fs2 and scb9328 boards

* Patches by Marc Leeman, 23 Jul 2004:
  - Add define for the PCI/Memory Buffer Configuration Register
  - corrected comments in cpu/mpc824x/cpu_init.c

* Add support for multiple serial interfaces
  (for example to allow modem dial-in / dial-out)

1 files changed, 37 insertions, 0 deletions

diff --git a/doc/README.serial_multi b/doc/README.serial_multi
new file mode 100644
index 00000000000..1d73376b2c7
--- /dev/null
+++ b/doc/README.serial_multi
@@ -0,0 +1,37 @@
+The support for multiple serial interfaces as implemented is mainly
+intended to allow for modem dial-in / dial-out while still being able
+to use a serial console on a (different) serial port.
+
+At the moment, the ports must be split on a SMC and a SCC port  on  a
+8xx processor; other configurations are not (yet) supported.
+
+Support for hardware handshake has not been implemented yet (but is
+in the works).
+
+*) The default console depends on the keys pressed:
+	- SMC if keys not pressed (modem not enabled)
+	- SCC if keys pressed (modem enabled)
+
+*) The console can be switched to SCC by any of the following commands:
+
+	setenv stdout serial_scc
+	setenv stdin serial_scc
+	setenv stderr serial_scc
+
+*) The console can be switched to SMC by any of the following commands:
+
+	setenv stdout serial_smc
+	setenv stdin serial_smc
+	setenv stderr serial_smc
+
+*) If a file descriptor is set to "serial" then the current serial device
+will be used which, in turn, can be switched by above commands.
+
+*) The baudrate is the same for all serial devices. But it can be switched
+just after switching the console:
+
+	setenv sout serial_scc; setenv baudrate 38400
+
+After that press 'enter' at the SCC console. Note that baudrates <38400
+are not allowed on LWMON with watchdog enabled (see CFG_BAUDRATE_TABLE in
+include/configs/lwmon.h).