diff options
-rw-r--r-- | drivers/net/fec_mxc.c | 144 | ||||
-rw-r--r-- | drivers/net/fec_mxc.h | 5 |
2 files changed, 101 insertions, 48 deletions
diff --git a/drivers/net/fec_mxc.c b/drivers/net/fec_mxc.c index db8ebfaf8a2..1fdd071e385 100644 --- a/drivers/net/fec_mxc.c +++ b/drivers/net/fec_mxc.c @@ -70,34 +70,15 @@ static void swap_packet(uint32_t *packet, int length) #endif /* - * The i.MX28 has two ethernet interfaces, but they are not equal. - * Only the first one can access the MDIO bus. - */ -#ifdef CONFIG_MX28 -static inline struct ethernet_regs *fec_miiphy_fec_to_eth(struct fec_priv *fec) -{ - return (struct ethernet_regs *)MXS_ENET0_BASE; -} -#else -static inline struct ethernet_regs *fec_miiphy_fec_to_eth(struct fec_priv *fec) -{ - return fec->eth; -} -#endif - -/* * MII-interface related functions */ -static int fec_miiphy_read(const char *dev, uint8_t phyAddr, uint8_t regAddr, - uint16_t *retVal) +static int fec_mdio_read(struct ethernet_regs *eth, uint8_t phyAddr, + uint8_t regAddr) { - struct eth_device *edev = eth_get_dev_by_name(dev); - struct fec_priv *fec = (struct fec_priv *)edev->priv; - struct ethernet_regs *eth = fec_miiphy_fec_to_eth(fec); - uint32_t reg; /* convenient holder for the PHY register */ uint32_t phy; /* convenient holder for the PHY */ uint32_t start; + int val; /* * reading from any PHY's register is done by properly @@ -129,10 +110,10 @@ static int fec_miiphy_read(const char *dev, uint8_t phyAddr, uint8_t regAddr, /* * it's now safe to read the PHY's register */ - *retVal = readl(ð->mii_data); - debug("fec_miiphy_read: phy: %02x reg:%02x val:%#x\n", phyAddr, - regAddr, *retVal); - return 0; + val = (unsigned short)readl(ð->mii_data); + debug("%s: phy: %02x reg:%02x val:%#x\n", __func__, phyAddr, + regAddr, val); + return val; } static void fec_mii_setspeed(struct fec_priv *fec) @@ -143,16 +124,12 @@ static void fec_mii_setspeed(struct fec_priv *fec) */ writel((((imx_get_fecclk() / 1000000) + 2) / 5) << 1, &fec->eth->mii_speed); - debug("fec_init: mii_speed %08x\n", - readl(&fec->eth->mii_speed)); + debug("%s: mii_speed %08x\n", __func__, readl(&fec->eth->mii_speed)); } -static int fec_miiphy_write(const char *dev, uint8_t phyAddr, uint8_t regAddr, - uint16_t data) -{ - struct eth_device *edev = eth_get_dev_by_name(dev); - struct fec_priv *fec = (struct fec_priv *)edev->priv; - struct ethernet_regs *eth = fec_miiphy_fec_to_eth(fec); +static int fec_mdio_write(struct ethernet_regs *eth, uint8_t phyAddr, + uint8_t regAddr, uint16_t data) +{ uint32_t reg; /* convenient holder for the PHY register */ uint32_t phy; /* convenient holder for the PHY */ uint32_t start; @@ -178,15 +155,28 @@ static int fec_miiphy_write(const char *dev, uint8_t phyAddr, uint8_t regAddr, * clear MII interrupt bit */ writel(FEC_IEVENT_MII, ð->ievent); - debug("fec_miiphy_write: phy: %02x reg:%02x val:%#x\n", phyAddr, + debug("%s: phy: %02x reg:%02x val:%#x\n", __func__, phyAddr, regAddr, data); return 0; } +int fec_phy_read(struct mii_dev *bus, int phyAddr, int dev_addr, int regAddr) +{ + return fec_mdio_read(bus->priv, phyAddr, regAddr); +} + +int fec_phy_write(struct mii_dev *bus, int phyAddr, int dev_addr, int regAddr, + u16 data) +{ + return fec_mdio_write(bus->priv, phyAddr, regAddr, data); +} + +#ifndef CONFIG_PHYLIB static int miiphy_restart_aneg(struct eth_device *dev) { struct fec_priv *fec = (struct fec_priv *)dev->priv; + struct ethernet_regs *eth = fec->bus->priv; int ret = 0; /* @@ -194,19 +184,18 @@ static int miiphy_restart_aneg(struct eth_device *dev) * Reset PHY, then delay 300ns */ #ifdef CONFIG_MX27 - miiphy_write(dev->name, fec->phy_id, MII_DCOUNTER, 0x00FF); + fec_mdio_write(eth, fec->phy_id, MII_DCOUNTER, 0x00FF); #endif - miiphy_write(dev->name, fec->phy_id, MII_BMCR, - BMCR_RESET); + fec_mdio_write(eth, fec->phy_id, MII_BMCR, BMCR_RESET); udelay(1000); /* * Set the auto-negotiation advertisement register bits */ - miiphy_write(dev->name, fec->phy_id, MII_ADVERTISE, + fec_mdio_write(eth, fec->phy_id, MII_ADVERTISE, LPA_100FULL | LPA_100HALF | LPA_10FULL | LPA_10HALF | PHY_ANLPAR_PSB_802_3); - miiphy_write(dev->name, fec->phy_id, MII_BMCR, + fec_mdio_write(eth, fec->phy_id, MII_BMCR, BMCR_ANENABLE | BMCR_ANRESTART); if (fec->mii_postcall) @@ -218,8 +207,9 @@ static int miiphy_restart_aneg(struct eth_device *dev) static int miiphy_wait_aneg(struct eth_device *dev) { uint32_t start; - uint16_t status; + int status; struct fec_priv *fec = (struct fec_priv *)dev->priv; + struct ethernet_regs *eth = fec->bus->priv; /* * Wait for AN completion @@ -231,9 +221,9 @@ static int miiphy_wait_aneg(struct eth_device *dev) return -1; } - if (miiphy_read(dev->name, fec->phy_id, - MII_BMSR, &status)) { - printf("%s: Autonegotiation failed. status: 0x%04x\n", + status = fec_mdio_read(eth, fec->phy_id, MII_BMSR); + if (status < 0) { + printf("%s: Autonegotiation failed. status: %d\n", dev->name, status); return -1; } @@ -241,6 +231,8 @@ static int miiphy_wait_aneg(struct eth_device *dev) return 0; } +#endif + static int fec_rx_task_enable(struct fec_priv *fec) { writel(1 << 24, &fec->eth->r_des_active); @@ -372,6 +364,21 @@ static int fec_set_hwaddr(struct eth_device *dev) return 0; } +static void fec_eth_phy_config(struct eth_device *dev) +{ +#ifdef CONFIG_PHYLIB + struct fec_priv *fec = (struct fec_priv *)dev->priv; + struct phy_device *phydev; + + phydev = phy_connect(fec->bus, fec->phy_id, dev, + PHY_INTERFACE_MODE_RGMII); + if (phydev) { + fec->phydev = phydev; + phy_config(phydev); + } +#endif +} + /** * Start the FEC engine * @param[in] dev Our device to handle @@ -428,9 +435,21 @@ static int fec_open(struct eth_device *edev) } #endif +#ifdef CONFIG_PHYLIB + if (!fec->phydev) + fec_eth_phy_config(edev); + if (fec->phydev) { + /* Start up the PHY */ + phy_startup(fec->phydev); + speed = fec->phydev->speed; + } else { + speed = _100BASET; + } +#else miiphy_wait_aneg(edev); speed = miiphy_speed(edev->name, fec->phy_id); miiphy_duplex(edev->name, fec->phy_id); +#endif #ifdef FEC_QUIRK_ENET_MAC { @@ -558,9 +577,10 @@ static int fec_init(struct eth_device *dev, bd_t* bd) fec_tbd_init(fec); +#ifndef CONFIG_PHYLIB if (fec->xcv_type != SEVENWIRE) miiphy_restart_aneg(dev); - +#endif fec_open(dev); return 0; } @@ -762,6 +782,7 @@ static int fec_probe(bd_t *bd, int dev_id, int phy_id, uint32_t base_addr) { struct eth_device *edev; struct fec_priv *fec; + struct mii_dev *bus; unsigned char ethaddr[6]; uint32_t start; int ret = 0; @@ -836,15 +857,40 @@ static int fec_probe(bd_t *bd, int dev_id, int phy_id, uint32_t base_addr) } fec->phy_id = phy_id; - miiphy_register(edev->name, fec_miiphy_read, fec_miiphy_write); - + bus = mdio_alloc(); + if (!bus) { + printf("mdio_alloc failed\n"); + ret = -ENOMEM; + goto err3; + } + bus->read = fec_phy_read; + bus->write = fec_phy_write; + sprintf(bus->name, edev->name); +#ifdef CONFIG_MX28 + /* + * The i.MX28 has two ethernet interfaces, but they are not equal. + * Only the first one can access the MDIO bus. + */ + bus->priv = (struct ethernet_regs *)MXS_ENET0_BASE; +#else + bus->priv = fec->eth; +#endif + ret = mdio_register(bus); + if (ret) { + printf("mdio_register failed\n"); + free(bus); + ret = -ENOMEM; + goto err3; + } + fec->bus = bus; eth_register(edev); if (fec_get_hwaddr(edev, dev_id, ethaddr) == 0) { debug("got MAC%d address from fuse: %pM\n", dev_id, ethaddr); memcpy(edev->enetaddr, ethaddr, 6); } - + /* Configure phy */ + fec_eth_phy_config(edev); return ret; err3: @@ -877,9 +923,11 @@ int fecmxc_initialize_multi(bd_t *bd, int dev_id, int phy_id, uint32_t addr) return lout; } +#ifndef CONFIG_PHYLIB int fecmxc_register_mii_postcall(struct eth_device *dev, int (*cb)(int)) { struct fec_priv *fec = (struct fec_priv *)dev->priv; fec->mii_postcall = cb; return 0; } +#endif diff --git a/drivers/net/fec_mxc.h b/drivers/net/fec_mxc.h index af33d2169ce..2eb78037fcb 100644 --- a/drivers/net/fec_mxc.h +++ b/drivers/net/fec_mxc.h @@ -286,7 +286,12 @@ struct fec_priv { void *base_ptr; int dev_id; int phy_id; + struct mii_dev *bus; +#ifdef CONFIG_PHYLIB + struct phy_device *phydev; +#else int (*mii_postcall)(int); +#endif }; /** |