diff options
| -rw-r--r-- | drivers/mmc/Kconfig | 8 | ||||
| -rw-r--r-- | drivers/mmc/fsl_esdhc.c | 50 | ||||
| -rw-r--r-- | include/fsl_esdhc.h | 14 |
3 files changed, 67 insertions, 5 deletions
diff --git a/drivers/mmc/Kconfig b/drivers/mmc/Kconfig index 88582db58c9..14d79139864 100644 --- a/drivers/mmc/Kconfig +++ b/drivers/mmc/Kconfig @@ -755,6 +755,14 @@ config FSL_ESDHC This selects support for the eSDHC (Enhanced Secure Digital Host Controller) found on numerous Freescale/NXP SoCs. +config FSL_ESDHC_SUPPORT_ADMA2 + bool "enable ADMA2 support" + depends on FSL_ESDHC + select MMC_SDHCI_ADMA_HELPERS + help + This enables support for the ADMA2 transfer mode. If supported by the + eSDHC it will allow 64bit DMA addresses. + config FSL_ESDHC_33V_IO_RELIABILITY_WORKAROUND bool "enable eSDHC workaround for 3.3v IO reliability issue" depends on FSL_ESDHC && DM_MMC diff --git a/drivers/mmc/fsl_esdhc.c b/drivers/mmc/fsl_esdhc.c index 15f8175660f..642784e1f35 100644 --- a/drivers/mmc/fsl_esdhc.c +++ b/drivers/mmc/fsl_esdhc.c @@ -27,6 +27,7 @@ #include <linux/bitops.h> #include <linux/delay.h> #include <linux/dma-mapping.h> +#include <sdhci.h> DECLARE_GLOBAL_DATA_PTR; @@ -52,8 +53,9 @@ struct fsl_esdhc { char reserved1[8]; /* reserved */ uint fevt; /* Force event register */ uint admaes; /* ADMA error status register */ - uint adsaddr; /* ADMA system address register */ - char reserved2[160]; + uint adsaddrl; /* ADMA system address low register */ + uint adsaddrh; /* ADMA system address high register */ + char reserved2[156]; uint hostver; /* Host controller version register */ char reserved3[4]; /* reserved */ uint dmaerraddr; /* DMA error address register */ @@ -99,6 +101,7 @@ struct fsl_esdhc_priv { struct mmc *mmc; #endif struct udevice *dev; + struct sdhci_adma_desc *adma_desc_table; dma_addr_t dma_addr; }; @@ -228,6 +231,7 @@ static void esdhc_setup_dma(struct fsl_esdhc_priv *priv, struct mmc_data *data) { uint trans_bytes = data->blocksize * data->blocks; struct fsl_esdhc *regs = priv->esdhc_regs; + phys_addr_t adma_addr; void *buf; if (data->flags & MMC_DATA_WRITE) @@ -237,9 +241,29 @@ static void esdhc_setup_dma(struct fsl_esdhc_priv *priv, struct mmc_data *data) priv->dma_addr = dma_map_single(buf, trans_bytes, mmc_get_dma_dir(data)); - if (upper_32_bits(priv->dma_addr)) - printf("Cannot use 64 bit addresses with SDMA\n"); - esdhc_write32(®s->dsaddr, lower_32_bits(priv->dma_addr)); + + if (IS_ENABLED(CONFIG_FSL_ESDHC_SUPPORT_ADMA2) && + priv->adma_desc_table) { + debug("Using ADMA2\n"); + /* prefer ADMA2 if it is available */ + sdhci_prepare_adma_table(priv->adma_desc_table, data, + priv->dma_addr); + + adma_addr = virt_to_phys(priv->adma_desc_table); + esdhc_write32(®s->adsaddrl, lower_32_bits(adma_addr)); + if (IS_ENABLED(CONFIG_DMA_ADDR_T_64BIT)) + esdhc_write32(®s->adsaddrh, upper_32_bits(adma_addr)); + esdhc_clrsetbits32(®s->proctl, PROCTL_DMAS_MASK, + PROCTL_DMAS_ADMA2); + } else { + debug("Using SDMA\n"); + if (upper_32_bits(priv->dma_addr)) + printf("Cannot use 64 bit addresses with SDMA\n"); + esdhc_write32(®s->dsaddr, lower_32_bits(priv->dma_addr)); + esdhc_clrsetbits32(®s->proctl, PROCTL_DMAS_MASK, + PROCTL_DMAS_SDMA); + } + esdhc_write32(®s->blkattr, data->blocks << 16 | data->blocksize); } @@ -911,6 +935,7 @@ static int fsl_esdhc_probe(struct udevice *dev) struct mmc_uclass_priv *upriv = dev_get_uclass_priv(dev); struct fsl_esdhc_plat *plat = dev_get_platdata(dev); struct fsl_esdhc_priv *priv = dev_get_priv(dev); + u32 caps, hostver; fdt_addr_t addr; struct mmc *mmc; int ret; @@ -925,6 +950,21 @@ static int fsl_esdhc_probe(struct udevice *dev) #endif priv->dev = dev; + if (IS_ENABLED(CONFIG_FSL_ESDHC_SUPPORT_ADMA2)) { + /* + * Only newer eSDHC controllers can do ADMA2 if the ADMA flag + * is set in the host capabilities register. + */ + caps = esdhc_read32(&priv->esdhc_regs->hostcapblt); + hostver = esdhc_read32(&priv->esdhc_regs->hostver); + if (caps & HOSTCAPBLT_DMAS && + HOSTVER_VENDOR(hostver) > VENDOR_V_22) { + priv->adma_desc_table = sdhci_adma_init(); + if (!priv->adma_desc_table) + debug("Could not allocate ADMA tables, falling back to SDMA\n"); + } + } + if (gd->arch.sdhc_per_clk) { priv->sdhc_clk = gd->arch.sdhc_per_clk; priv->is_sdhc_per_clk = true; diff --git a/include/fsl_esdhc.h b/include/fsl_esdhc.h index cc119668d6a..e6f1c75e27c 100644 --- a/include/fsl_esdhc.h +++ b/include/fsl_esdhc.h @@ -97,6 +97,10 @@ #define PROCTL_DTW_4 0x00000002 #define PROCTL_DTW_8 0x00000004 #define PROCTL_D3CD 0x00000008 +#define PROCTL_DMAS_MASK 0x00000300 +#define PROCTL_DMAS_SDMA 0x00000000 +#define PROCTL_DMAS_ADMA1 0x00000100 +#define PROCTL_DMAS_ADMA2 0x00000300 #define PROCTL_VOLT_SEL 0x00000400 #define CMDARG 0x0002e008 @@ -187,6 +191,16 @@ #define MAX_TUNING_LOOP 40 +#define HOSTVER_VENDOR(x) (((x) >> 8) & 0xff) +#define VENDOR_V_10 0x00 +#define VENDOR_V_20 0x10 +#define VENDOR_V_21 0x11 +#define VENDOR_V_22 0x12 +#define VENDOR_V_23 0x13 +#define VENDOR_V_30 0x20 +#define VENDOR_V_31 0x21 +#define VENDOR_V_32 0x22 + struct fsl_esdhc_cfg { phys_addr_t esdhc_base; u32 sdhc_clk; |