aboutsummaryrefslogtreecommitdiff
diff options
context:
space:
mode:
Diffstat
-rw-r--r--board/esd/cpci405/cpci405.c76
-rw-r--r--include/configs/CPCI405.h5
-rw-r--r--include/configs/CPCI4052.h6
-rw-r--r--include/configs/CPCI405AB.h5
-rw-r--r--include/configs/CPCI405DT.h5
5 files changed, 76 insertions, 21 deletions
diff --git a/board/esd/cpci405/cpci405.c b/board/esd/cpci405/cpci405.c
index f80361081a6..263b75d3a1a 100644
--- a/board/esd/cpci405/cpci405.c
+++ b/board/esd/cpci405/cpci405.c
@@ -23,9 +23,11 @@
#include <common.h>
#include <asm/processor.h>
+#include <asm/io.h>
#include <command.h>
#include <malloc.h>
#include <net.h>
+#include <pci.h>
DECLARE_GLOBAL_DATA_PTR;
@@ -179,11 +181,15 @@ int board_early_init_f (void)
mtdcr(uicsr, 0xFFFFFFFF); /* clear all ints */
mtdcr(uicer, 0x00000000); /* disable all ints */
mtdcr(uiccr, 0x00000000); /* set all to be non-critical*/
+#ifdef CONFIG_CPCI405_6U
if (cpci405_version() == 3) {
mtdcr(uicpr, 0xFFFFFF99); /* set int polarities */
} else {
mtdcr(uicpr, 0xFFFFFF81); /* set int polarities */
}
+#else
+ mtdcr(uicpr, 0xFFFFFF81); /* set int polarities */
+#endif
mtdcr(uictr, 0x10000000); /* set int trigger levels */
mtdcr(uicvcr, 0x00000001); /* set vect base=0,INT0 highest priority*/
mtdcr(uicsr, 0xFFFFFFFF); /* clear all ints */
@@ -227,10 +233,10 @@ int cpci405_version(void)
*/
cntrl0Reg = mfdcr(cntrl0);
mtdcr(cntrl0, cntrl0Reg | 0x03000000);
- out32(GPIO0_ODR, in32(GPIO0_ODR) & ~0x00180000);
- out32(GPIO0_TCR, in32(GPIO0_TCR) & ~0x00180000);
+ out_be32((void*)GPIO0_ODR, in_be32((void*)GPIO0_ODR) & ~0x00180000);
+ out_be32((void*)GPIO0_TCR, in_be32((void*)GPIO0_TCR) & ~0x00180000);
udelay(1000); /* wait some time before reading input */
- value = in32(GPIO0_IR) & 0x00180000; /* get config bits */
+ value = in_be32((void*)GPIO0_IR) & 0x00180000; /* get config bits */
/*
* Restore GPIO settings
@@ -245,7 +251,7 @@ int cpci405_version(void)
/* CS2==0 && CS3==1 -> version 2 */
return 2;
case 0x00100000:
- /* CS2==1 && CS3==0 -> version 3 */
+ /* CS2==1 && CS3==0 -> version 3 or 6U board */
return 3;
case 0x00000000:
/* CS2==0 && CS3==0 -> version 4 */
@@ -283,7 +289,6 @@ int misc_init_r (void)
* On CPCI-405 version 2 the environment is saved in eeprom!
* FPGA can be gzip compressed (malloc) and booted this late.
*/
-
if (cpci405_version() >= 2) {
/*
* Setup GPIO pins (CS6+CS7 as GPIO)
@@ -354,6 +359,7 @@ int misc_init_r (void)
SET_FPGA(FPGA_PRG | FPGA_CLK | FPGA_DATA);
udelay(1000); /* wait 1ms */
+#ifdef CONFIG_CPCI405_6U
if (cpci405_version() == 3) {
volatile unsigned short *fpga_mode = (unsigned short *)CFG_FPGA_BASE_ADDR;
volatile unsigned char *leds = (unsigned char *)CFG_LED_ADDR;
@@ -375,6 +381,7 @@ int misc_init_r (void)
udelay(100);
*fpga_mode &= ~(CFG_FPGA_MODE_DUART_RESET);
}
+#endif
}
else {
puts("\n*** U-Boot Version does not match Board Version!\n");
@@ -493,12 +500,6 @@ int checkboard (void)
#endif
putc ('\n');
-
- /*
- * Disable sleep mode in LXT971
- */
- lxt971_no_sleep();
-
return 0;
}
@@ -511,24 +512,22 @@ long int initdram (int board_type)
mtdcr(memcfga, mem_mb0cf);
val = mfdcr(memcfgd);
-#if 0
- printf("\nmb0cf=%x\n", val); /* test-only */
- printf("strap=%x\n", mfdcr(strap)); /* test-only */
-#endif
-
return (4*1024*1024 << ((val & 0x000e0000) >> 17));
}
-/* ------------------------------------------------------------------------- */
-int testdram (void)
+void reset_phy(void)
{
- /* TODO: XXX XXX XXX */
- printf ("test: 16 MB - ok\n");
+#ifdef CONFIG_LXT971_NO_SLEEP
- return (0);
+ /*
+ * Disable sleep mode in LXT971
+ */
+ lxt971_no_sleep();
+#endif
}
+
/* ------------------------------------------------------------------------- */
#ifdef CONFIG_CPCI405_VER2
@@ -552,6 +551,41 @@ void ide_set_reset(int on)
#endif /* CONFIG_CPCI405_VER2 */
+#if defined(CONFIG_PCI) && defined(CFG_PCI_PRE_INIT)
+void cpci405_pci_fixup_irq(struct pci_controller *hose, pci_dev_t dev)
+{
+ unsigned char int_line = 0xff;
+
+ /*
+ * Write pci interrupt line register (cpci405 specific)
+ */
+ switch (PCI_DEV(dev) & 0x03) {
+ case 0:
+ int_line = 27 + 2;
+ break;
+ case 1:
+ int_line = 27 + 3;
+ break;
+ case 2:
+ int_line = 27 + 0;
+ break;
+ case 3:
+ int_line = 27 + 1;
+ break;
+ }
+
+ pci_hose_write_config_byte(hose, dev, PCI_INTERRUPT_LINE, int_line);
+}
+
+int pci_pre_init(struct pci_controller *hose)
+{
+ hose->fixup_irq = cpci405_pci_fixup_irq;
+ return 1;
+}
+#endif /* defined(CONFIG_PCI) && defined(CFG_PCI_PRE_INIT) */
+
+
+
#ifdef CONFIG_CPCI405AB
#define ONE_WIRE_CLEAR (*(volatile unsigned short *)(CFG_FPGA_BASE_ADDR + CFG_FPGA_MODE) \
diff --git a/include/configs/CPCI405.h b/include/configs/CPCI405.h
index 047e2f1eef9..67f75811301 100644
--- a/include/configs/CPCI405.h
+++ b/include/configs/CPCI405.h
@@ -55,6 +55,10 @@
#define CONFIG_MII 1 /* MII PHY management */
#define CONFIG_PHY_ADDR 0 /* PHY address */
#define CONFIG_LXT971_NO_SLEEP 1 /* disable sleep mode in LXT971 */
+#define CONFIG_RESET_PHY_R 1 /* use reset_phy() to disable phy sleep mode */
+
+#define CONFIG_NET_MULTI 1
+#undef CONFIG_HAS_ETH1
#define CONFIG_BOOTP_MASK (CONFIG_BOOTP_DEFAULT | \
CONFIG_BOOTP_DNS | \
@@ -139,6 +143,7 @@
#define PCI_HOST_AUTO 2 /* detected via arbiter enable */
#define CONFIG_PCI /* include pci support */
+#define CFG_PCI_PRE_INIT /* pci interrupt mapping etc. */
#define CONFIG_PCI_HOST PCI_HOST_AUTO /* select pci host function */
#define CONFIG_PCI_PNP /* do pci plug-and-play */
/* resource configuration */
diff --git a/include/configs/CPCI4052.h b/include/configs/CPCI4052.h
index d756f447f7f..8abdbdc6df2 100644
--- a/include/configs/CPCI4052.h
+++ b/include/configs/CPCI4052.h
@@ -37,6 +37,7 @@
#define CONFIG_4xx 1 /* ...member of PPC4xx family */
#define CONFIG_CPCI405 1 /* ...on a CPCI405 board */
#define CONFIG_CPCI405_VER2 1 /* ...version 2 */
+#undef CONFIG_CPCI405_6U /* enable this for 6U boards */
#define CONFIG_BOARD_EARLY_INIT_F 1 /* call board_early_init_f() */
@@ -56,6 +57,10 @@
#define CONFIG_MII 1 /* MII PHY management */
#define CONFIG_PHY_ADDR 0 /* PHY address */
#define CONFIG_LXT971_NO_SLEEP 1 /* disable sleep mode in LXT971 */
+#define CONFIG_RESET_PHY_R 1 /* use reset_phy() to disable phy sleep mode */
+
+#define CONFIG_NET_MULTI 1
+#undef CONFIG_HAS_ETH1
#define CONFIG_RTC_M48T35A 1 /* ST Electronics M48 timekeeper */
@@ -166,6 +171,7 @@
#define PCI_HOST_AUTO 2 /* detected via arbiter enable */
#define CONFIG_PCI /* include pci support */
+#define CFG_PCI_PRE_INIT /* pci interrupt mapping etc. */
#define CONFIG_PCI_HOST PCI_HOST_AUTO /* select pci host function */
#define CONFIG_PCI_PNP /* do pci plug-and-play */
/* resource configuration */
diff --git a/include/configs/CPCI405AB.h b/include/configs/CPCI405AB.h
index 852d94a410a..ab6d1168f1d 100644
--- a/include/configs/CPCI405AB.h
+++ b/include/configs/CPCI405AB.h
@@ -57,6 +57,10 @@
#define CONFIG_MII 1 /* MII PHY management */
#define CONFIG_PHY_ADDR 0 /* PHY address */
#define CONFIG_LXT971_NO_SLEEP 1 /* disable sleep mode in LXT971 */
+#define CONFIG_RESET_PHY_R 1 /* use reset_phy() to disable phy sleep mode */
+
+#define CONFIG_NET_MULTI 1
+#undef CONFIG_HAS_ETH1
#define CONFIG_RTC_M48T35A 1 /* ST Electronics M48 timekeeper */
@@ -150,6 +154,7 @@
#define PCI_HOST_AUTO 2 /* detected via arbiter enable */
#define CONFIG_PCI /* include pci support */
+#define CFG_PCI_PRE_INIT /* pci interrupt mapping etc. */
#define CONFIG_PCI_HOST PCI_HOST_AUTO /* select pci host function */
#define CONFIG_PCI_PNP /* do pci plug-and-play */
/* resource configuration */
diff --git a/include/configs/CPCI405DT.h b/include/configs/CPCI405DT.h
index 2260327c3f8..42ec0801ad7 100644
--- a/include/configs/CPCI405DT.h
+++ b/include/configs/CPCI405DT.h
@@ -56,6 +56,10 @@
#define CONFIG_MII 1 /* MII PHY management */
#define CONFIG_PHY_ADDR 0 /* PHY address */
#define CONFIG_LXT971_NO_SLEEP 1 /* disable sleep mode in LXT971 */
+#define CONFIG_RESET_PHY_R 1 /* use reset_phy() to disable phy sleep mode */
+
+#define CONFIG_NET_MULTI 1
+#undef CONFIG_HAS_ETH1
#define CONFIG_RTC_M48T35A 1 /* ST Electronics M48 timekeeper */
@@ -171,6 +175,7 @@
#define PCI_HOST_AUTO 2 /* detected via arbiter enable */
#define CONFIG_PCI /* include pci support */
+#define CFG_PCI_PRE_INIT /* pci interrupt mapping etc. */
#define CONFIG_PCI_HOST PCI_HOST_AUTO /* select pci host function */
#define CONFIG_PCI_PNP /* do pci plug-and-play */
/* resource configuration */
generated by cgit v1.2.3 (git 2.39.1) at 2024-11-11 09:57:09 +0000