diff options
Diffstat (limited to 'doc/README.t1040-l2switch')
| -rw-r--r-- | doc/README.t1040-l2switch | 27 |
1 files changed, 20 insertions, 7 deletions
diff --git a/doc/README.t1040-l2switch b/doc/README.t1040-l2switch index 14dbf31bf23..4e0f418c7c7 100644 --- a/doc/README.t1040-l2switch +++ b/doc/README.t1040-l2switch @@ -24,16 +24,29 @@ Switch interfaces: Commands Overview: ============= Commands supported - - enable/disable a port - - check a port's link speed, duplexity and status. + - enable/disable a port or show its configuration (speed, duplexity, status, etc.) + - port statistics + - MAC learning + - add/remove FDB entries + - Port-based VLAN + - Private/Shared VLAN learning + - VLAN ingress filtering Commands syntax - ethsw port <port_nr> enable|disable - enable/disable an l2 switch port - ethsw port <port_nr> show - show an l2 switch port's configuration +ethsw [port <port_no>] { enable | disable | show } - enable/disable a port; show a port's configuration +ethsw [port <port_no>] statistics { [help] | [clear] } - show an l2 switch port's statistics +ethsw [port <port_no>] learning { [help] | show | auto | disable } - enable/disable/show learning configuration on a port +ethsw [port <port_no>] [vlan <vid>] fdb { [help] | show | flush | { add | del } <mac> } - add/delete a mac entry in FDB; use show to see FDB entries; + if [vlan <vid>] is missing, VID 1 will be used +ethsw [port <port_no>] pvid { [help] | show | <pvid> } - set/show PVID (ingress and egress VLAN tagging) for a port +ethsw [port <port_no>] vlan { [help] | show | add <vid> | del <vid> } - add a VLAN to a port (VLAN members) +ethsw [port <port_no>] untagged { [help] | show | all | none | pvid } - set egress tagging mode for a port +ethsw [port <port_no>] egress tag { [help] | show | pvid | classified } - configure VID source for egress tag. + Tag's VID could be the frame's classified VID or the PVID of the port +ethsw vlan fdb { [help] | show | shared | private } - make VLAN learning shared or private +ethsw [port <port_no>] ingress filtering { [help] | show | enable | disable } - enable/disable VLAN ingress filtering on port - port_nr=0..9; use "all" for all ports - -=> ethsw port all show +=> ethsw show Port Status Link Speed Duplex 0 enabled down 10 half 1 enabled down 10 half |