diff options
Diffstat (limited to 'drivers/net')
| -rw-r--r-- | drivers/net/phy/aquantia.c | 39 |
1 files changed, 39 insertions, 0 deletions
diff --git a/drivers/net/phy/aquantia.c b/drivers/net/phy/aquantia.c index d166d05d5bf..3b036d01c76 100644 --- a/drivers/net/phy/aquantia.c +++ b/drivers/net/phy/aquantia.c @@ -67,6 +67,13 @@ #define UP_RUN_STALL_OVERRIDE BIT(6) #define UP_RUN_STALL BIT(0) +#define AQUANTIA_PMA_RX_VENDOR_P1 0xe400 +#define AQUANTIA_PMA_RX_VENDOR_P1_MDI_MSK GENMASK(1, 0) +/* MDI reversal configured through registers */ +#define AQUANTIA_PMA_RX_VENDOR_P1_MDI_CFG BIT(1) +/* MDI reversal enabled */ +#define AQUANTIA_PMA_RX_VENDOR_P1_MDI_REV BIT(0) + /* * global start rate, the protocol associated with this speed is used by default * on SI. @@ -323,6 +330,36 @@ static int aquantia_set_proto(struct phy_device *phydev) return 0; } +static int aquantia_dts_config(struct phy_device *phydev) +{ +#ifdef CONFIG_DM_ETH + ofnode node = phydev->node; + u32 prop; + u16 reg; + + /* this code only works on gen2 and gen3 PHYs */ + if (phydev->drv->data != AQUANTIA_GEN2 && + phydev->drv->data != AQUANTIA_GEN3) + return -ENOTSUPP; + + if (!ofnode_valid(node)) + return 0; + + if (!ofnode_read_u32(node, "mdi-reversal", &prop)) { + debug("mdi-reversal = %d\n", (int)prop); + reg = phy_read(phydev, MDIO_MMD_PMAPMD, + AQUANTIA_PMA_RX_VENDOR_P1); + reg &= ~AQUANTIA_PMA_RX_VENDOR_P1_MDI_MSK; + reg |= AQUANTIA_PMA_RX_VENDOR_P1_MDI_CFG; + reg |= prop ? AQUANTIA_PMA_RX_VENDOR_P1_MDI_REV : 0; + phy_write(phydev, MDIO_MMD_PMAPMD, AQUANTIA_PMA_RX_VENDOR_P1, + reg); + } + +#endif + return 0; +} + static bool aquantia_link_is_up(struct phy_device *phydev) { u16 reg, regmask; @@ -415,6 +452,8 @@ int aquantia_config(struct phy_device *phydev) /* configure protocol based on phydev->interface */ aquantia_set_proto(phydev); + /* apply custom configuration based on DT */ + aquantia_dts_config(phydev); /* wake PHY back up */ phy_write(phydev, MDIO_MMD_VEND1, AQUANTIA_VND1_GLOBAL_SC, 0); |