diff options
Diffstat (limited to 'dts/upstream/src/arm64/xilinx/zynqmp-sck-kv-g-revB.dtso')
| -rw-r--r-- | dts/upstream/src/arm64/xilinx/zynqmp-sck-kv-g-revB.dtso | 340 |
1 files changed, 340 insertions, 0 deletions
diff --git a/dts/upstream/src/arm64/xilinx/zynqmp-sck-kv-g-revB.dtso b/dts/upstream/src/arm64/xilinx/zynqmp-sck-kv-g-revB.dtso new file mode 100644 index 00000000000..a7b8fffad49 --- /dev/null +++ b/dts/upstream/src/arm64/xilinx/zynqmp-sck-kv-g-revB.dtso @@ -0,0 +1,340 @@ +// SPDX-License-Identifier: GPL-2.0 +/* + * dts file for KV260 revA Carrier Card + * + * (C) Copyright 2020 - 2022, Xilinx, Inc. + * (C) Copyright 2022 - 2023, Advanced Micro Devices, Inc. + * + * Michal Simek <michal.simek@amd.com> + */ + +#include <dt-bindings/gpio/gpio.h> +#include <dt-bindings/net/ti-dp83867.h> +#include <dt-bindings/phy/phy.h> +#include <dt-bindings/pinctrl/pinctrl-zynqmp.h> + +/dts-v1/; +/plugin/; + +&{/} { + si5332_0: si5332-0 { /* u17 */ + compatible = "fixed-clock"; + #clock-cells = <0>; + clock-frequency = <125000000>; + }; + + si5332_1: si5332-1 { /* u17 */ + compatible = "fixed-clock"; + #clock-cells = <0>; + clock-frequency = <25000000>; + }; + + si5332_2: si5332-2 { /* u17 */ + compatible = "fixed-clock"; + #clock-cells = <0>; + clock-frequency = <48000000>; + }; + + si5332_3: si5332-3 { /* u17 */ + compatible = "fixed-clock"; + #clock-cells = <0>; + clock-frequency = <24000000>; + }; + + si5332_4: si5332-4 { /* u17 */ + compatible = "fixed-clock"; + #clock-cells = <0>; + clock-frequency = <26000000>; + }; + + si5332_5: si5332-5 { /* u17 */ + compatible = "fixed-clock"; + #clock-cells = <0>; + clock-frequency = <27000000>; + }; +}; + +&i2c1 { /* I2C_SCK C23/C24 - MIO from SOM */ + #address-cells = <1>; + #size-cells = <0>; + pinctrl-names = "default", "gpio"; + pinctrl-0 = <&pinctrl_i2c1_default>; + pinctrl-1 = <&pinctrl_i2c1_gpio>; + scl-gpios = <&gpio 24 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>; + sda-gpios = <&gpio 25 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>; + + /* u14 - 0x40 - ina260 */ + /* u43 - 0x2d - usb5744 */ + /* u27 - 0xe0 - STDP4320 DP/HDMI splitter */ +}; + +/* DP/USB 3.0 */ +&psgtr { + status = "okay"; + /* pcie, usb3, sata */ + clocks = <&si5332_5>, <&si5332_4>, <&si5332_0>; + clock-names = "ref0", "ref1", "ref2"; +}; + +&zynqmp_dpsub { + status = "okay"; + phy-names = "dp-phy0", "dp-phy1"; + phys = <&psgtr 1 PHY_TYPE_DP 0 0>, <&psgtr 0 PHY_TYPE_DP 1 0>; + assigned-clock-rates = <27000000>, <25000000>, <300000000>; +}; + +&zynqmp_dpdma { + status = "okay"; + assigned-clock-rates = <600000000>; +}; + +&usb0 { + status = "okay"; + pinctrl-names = "default"; + pinctrl-0 = <&pinctrl_usb0_default>; + phy-names = "usb3-phy"; + phys = <&psgtr 2 PHY_TYPE_USB3 0 1>; + assigned-clock-rates = <250000000>, <20000000>; +}; + +&dwc3_0 { + status = "okay"; + dr_mode = "host"; + snps,usb3_lpm_capable; + maximum-speed = "super-speed"; +}; + +&sdhci1 { /* on CC with tuned parameters */ + status = "okay"; + pinctrl-names = "default"; + pinctrl-0 = <&pinctrl_sdhci1_default>; + /* + * SD 3.0 requires level shifter and this property + * should be removed if the board has level shifter and + * need to work in UHS mode + */ + no-1-8-v; + disable-wp; + xlnx,mio-bank = <1>; + clk-phase-sd-hs = <126>, <60>; + clk-phase-uhs-sdr25 = <120>, <60>; + clk-phase-uhs-ddr50 = <126>, <48>; + assigned-clock-rates = <187498123>; + bus-width = <4>; +}; + +&gem3 { + status = "okay"; + pinctrl-names = "default"; + pinctrl-0 = <&pinctrl_gem3_default>; + phy-handle = <&phy0>; + phy-mode = "rgmii-id"; + assigned-clock-rates = <250000000>; + + mdio: mdio { + #address-cells = <1>; + #size-cells = <0>; + + phy0: ethernet-phy@1 { + #phy-cells = <1>; + reg = <1>; + compatible = "ethernet-phy-id2000.a231"; + ti,rx-internal-delay = <DP83867_RGMIIDCTL_2_25_NS>; + ti,tx-internal-delay = <DP83867_RGMIIDCTL_2_75_NS>; + ti,fifo-depth = <DP83867_PHYCR_FIFO_DEPTH_4_B_NIB>; + ti,dp83867-rxctrl-strap-quirk; + reset-assert-us = <100>; + reset-deassert-us = <280>; + reset-gpios = <&gpio 38 GPIO_ACTIVE_LOW>; + }; + }; +}; + +&pinctrl0 { + status = "okay"; + + pinctrl_gpio0_default: gpio0-default { + conf { + groups = "gpio0_38_grp"; + bias-pull-up; + power-source = <IO_STANDARD_LVCMOS18>; + }; + + mux { + groups = "gpio0_38_grp"; + function = "gpio0"; + }; + + conf-tx { + pins = "MIO38"; + bias-disable; + output-enable; + }; + }; + + pinctrl_uart1_default: uart1-default { + conf { + groups = "uart1_9_grp"; + slew-rate = <SLEW_RATE_SLOW>; + power-source = <IO_STANDARD_LVCMOS18>; + drive-strength = <12>; + }; + + conf-rx { + pins = "MIO37"; + bias-high-impedance; + }; + + conf-tx { + pins = "MIO36"; + bias-disable; + output-enable; + }; + + mux { + groups = "uart1_9_grp"; + function = "uart1"; + }; + }; + + pinctrl_i2c1_default: i2c1-default { + conf { + groups = "i2c1_6_grp"; + bias-pull-up; + slew-rate = <SLEW_RATE_SLOW>; + power-source = <IO_STANDARD_LVCMOS18>; + }; + + mux { + groups = "i2c1_6_grp"; + function = "i2c1"; + }; + }; + + pinctrl_i2c1_gpio: i2c1-gpio-grp { + conf { + groups = "gpio0_24_grp", "gpio0_25_grp"; + slew-rate = <SLEW_RATE_SLOW>; + power-source = <IO_STANDARD_LVCMOS18>; + }; + + mux { + groups = "gpio0_24_grp", "gpio0_25_grp"; + function = "gpio0"; + }; + }; + + pinctrl_gem3_default: gem3-default { + conf { + groups = "ethernet3_0_grp"; + slew-rate = <SLEW_RATE_SLOW>; + power-source = <IO_STANDARD_LVCMOS18>; + }; + + conf-rx { + pins = "MIO70", "MIO72", "MIO74"; + bias-high-impedance; + low-power-disable; + }; + + conf-bootstrap { + pins = "MIO71", "MIO73", "MIO75"; + bias-disable; + output-enable; + low-power-disable; + }; + + conf-tx { + pins = "MIO64", "MIO65", "MIO66", + "MIO67", "MIO68", "MIO69"; + bias-disable; + output-enable; + low-power-enable; + }; + + conf-mdio { + groups = "mdio3_0_grp"; + slew-rate = <SLEW_RATE_SLOW>; + power-source = <IO_STANDARD_LVCMOS18>; + bias-disable; + output-enable; + }; + + mux-mdio { + function = "mdio3"; + groups = "mdio3_0_grp"; + }; + + mux { + function = "ethernet3"; + groups = "ethernet3_0_grp"; + }; + }; + + pinctrl_usb0_default: usb0-default { + conf { + groups = "usb0_0_grp"; + power-source = <IO_STANDARD_LVCMOS18>; + }; + + conf-rx { + pins = "MIO52", "MIO53", "MIO55"; + bias-high-impedance; + drive-strength = <12>; + slew-rate = <SLEW_RATE_FAST>; + }; + + conf-tx { + pins = "MIO54", "MIO56", "MIO57", "MIO58", "MIO59", + "MIO60", "MIO61", "MIO62", "MIO63"; + bias-disable; + output-enable; + drive-strength = <4>; + slew-rate = <SLEW_RATE_SLOW>; + }; + + mux { + groups = "usb0_0_grp"; + function = "usb0"; + }; + }; + + pinctrl_sdhci1_default: sdhci1-default { + conf { + groups = "sdio1_0_grp"; + slew-rate = <SLEW_RATE_SLOW>; + power-source = <IO_STANDARD_LVCMOS18>; + bias-disable; + }; + + conf-cd { + groups = "sdio1_cd_0_grp"; + bias-high-impedance; + bias-pull-up; + slew-rate = <SLEW_RATE_SLOW>; + power-source = <IO_STANDARD_LVCMOS18>; + }; + + mux-cd { + groups = "sdio1_cd_0_grp"; + function = "sdio1_cd"; + }; + + mux { + groups = "sdio1_0_grp"; + function = "sdio1"; + }; + }; +}; + +&gpio { + status = "okay"; + pinctrl-names = "default"; + pinctrl-0 = <&pinctrl_gpio0_default>; +}; + +&uart1 { + status = "okay"; + pinctrl-names = "default"; + pinctrl-0 = <&pinctrl_uart1_default>; +}; |