blob: c1fb48f0cdd9cd1915534c989377ef756a4ef407 (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
|
.. SPDX-License-Identifier: GPL-2.0+
imxrt1050-evk
=============
How to use U-Boot on NXP i.MXRT1050 EVK
---------------------------------------
- Build U-Boot for i.MXRT1050 EVK:
.. code-block:: bash
$ make mrproper
$ make imxrt1050-evk_defconfig
$ make
This will generate the SPL image called SPL and the u-boot.img.
- Flash the SPL image into the micro SD card:
.. code-block:: bash
$sudo dd if=SPL of=/dev/sdX bs=1k seek=1 conv=notrunc; sync
- Flash the u-boot.img image into the micro SD card:
.. code-block:: bash
$sudo dd if=u-boot.img of=/dev/sdX bs=1k seek=128 conv=notrunc; sync
- Jumper settings::
SW7: 1 0 1 0
where 0 means bottom position and 1 means top position (from the
switch label numbers reference).
- Connect the USB cable between the EVK and the PC for the console.
The USB console connector is the one close the ethernet connector
- Insert the micro SD card in the board, power it up and U-Boot messages should come up.
|
