1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
201
202
203
204
205
206
207
208
209
210
211
212
213
214
215
216
217
218
219
220
221
222
223
224
225
226
227
228
229
230
231
232
233
234
235
236
237
238
239
240
241
242
243
244
245
246
247
248
249
250
251
252
253
254
255
256
257
258
259
260
261
262
263
264
265
266
267
268
269
270
271
272
273
274
275
276
277
278
279
280
281
282
283
284
285
286
287
288
289
290
291
292
293
294
295
296
297
298
299
300
301
302
303
304
305
306
307
308
309
310
311
312
313
314
315
316
317
318
319
320
321
322
323
324
325
326
327
328
|
// SPDX-License-Identifier: GPL-2.0+
/*
* Holtek HT1380/HT1381 Serial Timekeeper Chip
*
* Communication with the chip is vendor-specific.
* It is done via 3 GPIO pins: reset, clock, and data.
* Describe in .dts this way:
*
* rtc {
* compatible = "holtek,ht1380";
* rst-gpios = <&gpio 19 GPIO_ACTIVE_LOW>;
* clk-gpios = <&gpio 20 GPIO_ACTIVE_HIGH>;
* dat-gpios = <&gpio 21 GPIO_ACTIVE_HIGH>;
* };
*
*/
#include <dm.h>
#include <rtc.h>
#include <bcd.h>
#include <asm/gpio.h>
#include <linux/delay.h>
struct ht1380_priv {
struct gpio_desc rst_desc;
struct gpio_desc clk_desc;
struct gpio_desc dat_desc;
};
enum registers {
SEC,
MIN,
HOUR,
MDAY,
MONTH,
WDAY,
YEAR,
WP,
N_REGS
};
enum hour_mode {
AMPM_MODE = 0x80, /* RTC is in AM/PM mode */
PM_NOW = 0x20, /* set if PM, clear if AM */
};
static const int BURST = 0xbe;
static const int READ = 1;
static void ht1380_half_period_delay(void)
{
/*
* Delay for half a period. 1 us complies with the 500 KHz maximum
* input serial clock limit given by the datasheet.
*/
udelay(1);
}
static int ht1380_send_byte(struct ht1380_priv *priv, int byte)
{
int ret;
for (int bit = 0; bit < 8; bit++) {
ret = dm_gpio_set_value(&priv->dat_desc, byte >> bit & 1);
if (ret)
break;
ht1380_half_period_delay();
ret = dm_gpio_set_value(&priv->clk_desc, 1);
if (ret)
break;
ht1380_half_period_delay();
ret = dm_gpio_set_value(&priv->clk_desc, 0);
if (ret)
break;
}
return ret;
}
/*
* Leave reset state. The transfer operation can then be started.
*/
static int ht1380_reset_off(struct ht1380_priv *priv)
{
const unsigned int T_CC = 4; /* us, Reset to Clock Setup */
int ret;
/*
* Leave RESET state.
* Make sure we make the minimal delay required by the datasheet.
*/
ret = dm_gpio_set_value(&priv->rst_desc, 0);
udelay(T_CC);
return ret;
}
/*
* Enter reset state. Completes the transfer operation.
*/
static int ht1380_reset_on(struct ht1380_priv *priv)
{
const unsigned int T_CWH = 4; /* us, Reset Inactive Time */
int ret;
/*
* Enter RESET state.
* Make sure we make the minimal delay required by the datasheet.
*/
ret = dm_gpio_set_value(&priv->rst_desc, 1);
udelay(T_CWH);
return ret;
}
static int ht1380_rtc_get(struct udevice *dev, struct rtc_time *tm)
{
struct ht1380_priv *priv = dev_get_priv(dev);
int ret, i, bit, reg[N_REGS];
ret = dm_gpio_set_value(&priv->clk_desc, 0);
if (ret)
return ret;
ret = dm_gpio_set_dir_flags(&priv->dat_desc, GPIOD_IS_OUT);
if (ret)
return ret;
ret = ht1380_reset_off(priv);
if (ret)
goto exit;
ret = ht1380_send_byte(priv, BURST + READ);
if (ret)
goto exit;
ret = dm_gpio_set_dir_flags(&priv->dat_desc, GPIOD_IS_IN);
if (ret)
goto exit;
for (i = 0; i < N_REGS; i++) {
reg[i] = 0;
for (bit = 0; bit < 8; bit++) {
ht1380_half_period_delay();
ret = dm_gpio_set_value(&priv->clk_desc, 1);
if (ret)
goto exit;
ht1380_half_period_delay();
reg[i] |= dm_gpio_get_value(&priv->dat_desc) << bit;
ret = dm_gpio_set_value(&priv->clk_desc, 0);
if (ret)
goto exit;
}
}
ret = -EINVAL;
/* Correctness check: some bits are always zero */
if (reg[MIN] & 0x80 || reg[HOUR] & 0x40 || reg[MDAY] & 0xc0 ||
reg[MONTH] & 0xe0 || reg[WDAY] & 0xf8 || reg[WP] & 0x7f)
goto exit;
/* Correctness check: some registers are always non-zero */
if (!reg[MDAY] || !reg[MONTH] || !reg[WDAY])
goto exit;
tm->tm_sec = bcd2bin(reg[SEC]);
tm->tm_min = bcd2bin(reg[MIN]);
if (reg[HOUR] & AMPM_MODE) {
/* AM-PM Mode, range is 01-12 */
tm->tm_hour = bcd2bin(reg[HOUR] & 0x1f) % 12;
if (reg[HOUR] & PM_NOW) {
/* it is PM (otherwise AM) */
tm->tm_hour += 12;
}
} else {
/* 24-hour Mode, range is 0-23 */
tm->tm_hour = bcd2bin(reg[HOUR]);
}
tm->tm_mday = bcd2bin(reg[MDAY]);
tm->tm_mon = bcd2bin(reg[MONTH]);
tm->tm_year = 2000 + bcd2bin(reg[YEAR]);
tm->tm_wday = bcd2bin(reg[WDAY]) - 1;
tm->tm_yday = 0;
tm->tm_isdst = 0;
ret = 0;
exit:
ht1380_reset_on(priv);
return ret;
}
static int ht1380_write_protection_off(struct ht1380_priv *priv)
{
int ret;
const int PROTECT = 0x8e;
ret = ht1380_reset_off(priv);
if (ret)
return ret;
ret = ht1380_send_byte(priv, PROTECT);
if (ret)
return ret;
ret = ht1380_send_byte(priv, 0); /* WP bit is 0 */
if (ret)
return ret;
return ht1380_reset_on(priv);
}
static int ht1380_rtc_set(struct udevice *dev, const struct rtc_time *tm)
{
struct ht1380_priv *priv = dev_get_priv(dev);
int ret, i, reg[N_REGS];
ret = dm_gpio_set_value(&priv->clk_desc, 0);
if (ret)
return ret;
ret = dm_gpio_set_dir_flags(&priv->dat_desc, GPIOD_IS_OUT);
if (ret)
goto exit;
ret = ht1380_write_protection_off(priv);
if (ret)
goto exit;
reg[SEC] = bin2bcd(tm->tm_sec);
reg[MIN] = bin2bcd(tm->tm_min);
reg[HOUR] = bin2bcd(tm->tm_hour);
reg[MDAY] = bin2bcd(tm->tm_mday);
reg[MONTH] = bin2bcd(tm->tm_mon);
reg[WDAY] = bin2bcd(tm->tm_wday) + 1;
reg[YEAR] = bin2bcd(tm->tm_year - 2000);
reg[WP] = 0x80; /* WP bit is 1 */
ret = ht1380_reset_off(priv);
if (ret)
goto exit;
ret = ht1380_send_byte(priv, BURST);
for (i = 0; i < N_REGS && ret; i++)
ret = ht1380_send_byte(priv, reg[i]);
exit:
ht1380_reset_on(priv);
return ret;
}
static int ht1380_probe(struct udevice *dev)
{
int ret;
struct ht1380_priv *priv;
priv = dev_get_priv(dev);
if (!priv)
return -EINVAL;
ret = gpio_request_by_name(dev, "rst-gpios", 0,
&priv->rst_desc, GPIOD_IS_OUT);
if (ret)
goto fail_rst;
ret = gpio_request_by_name(dev, "clk-gpios", 0,
&priv->clk_desc, GPIOD_IS_OUT);
if (ret)
goto fail_clk;
ret = gpio_request_by_name(dev, "dat-gpios", 0,
&priv->dat_desc, 0);
if (ret)
goto fail_dat;
ret = ht1380_reset_on(priv);
if (ret)
goto fail;
return 0;
fail:
dm_gpio_free(dev, &priv->dat_desc);
fail_dat:
dm_gpio_free(dev, &priv->clk_desc);
fail_clk:
dm_gpio_free(dev, &priv->rst_desc);
fail_rst:
return ret;
}
static int ht1380_remove(struct udevice *dev)
{
struct ht1380_priv *priv = dev_get_priv(dev);
dm_gpio_free(dev, &priv->rst_desc);
dm_gpio_free(dev, &priv->clk_desc);
dm_gpio_free(dev, &priv->dat_desc);
return 0;
}
static const struct rtc_ops ht1380_rtc_ops = {
.get = ht1380_rtc_get,
.set = ht1380_rtc_set,
};
static const struct udevice_id ht1380_rtc_ids[] = {
{ .compatible = "holtek,ht1380" },
{ }
};
U_BOOT_DRIVER(rtc_ht1380) = {
.name = "rtc-ht1380",
.id = UCLASS_RTC,
.probe = ht1380_probe,
.remove = ht1380_remove,
.of_match = ht1380_rtc_ids,
.ops = &ht1380_rtc_ops,
.priv_auto = sizeof(struct ht1380_priv),
};
|