1 files changed, 47 insertions, 0 deletions
diff --git a/doc/board/nxp/mx6ullevk.rst b/doc/board/nxp/mx6ullevk.rst
new file mode 100644
index 00000000000..a26248a1e3b
--- /dev/null
+++ b/doc/board/nxp/mx6ullevk.rst
@@ -0,0 +1,47 @@
+.. SPDX-License-Identifier: GPL-2.0+
+
+mx6ullevk
+=========
+
+How to use U-Boot on Freescale MX6ULL 14x14 EVK
+-----------------------------------------------
+
+- First make sure you have installed the dtc package (device tree compiler):
+
+.. code-block:: bash
+
+   $ sudo apt-get install device-tree-compiler
+
+- Build U-Boot for MX6ULL 14x14 EVK:
+
+.. code-block:: bash
+
+   $ make mrproper
+   $ make mx6ull_14x14_evk_defconfig
+   $ make
+
+This generates the u-boot-dtb.imx image in the current directory.
+
+- Flash the u-boot-dtb.imx image into the micro SD card:
+
+.. code-block:: bash
+
+   $ sudo dd if=u-boot-dtb.imx of=/dev/sdb bs=1K seek=1 conv=notrunc && sync
+
+- Jumper settings::
+
+   SW601: 0 0 1 0
+   Sw602: 1 0
+
+Where 0 means bottom position and 1 means top position (from the switch label
+numbers reference).
+
+Connect the USB cable between the EVK and the PC for the console.
+(The USB console connector is the one close the push buttons)
+
+Insert the micro SD card in the board, power it up and U-Boot messages should
+come up.
+
+The link for the board: http://www.nxp.com/products/microcontrollers-and- \
+processors/arm-processors/i.mx-applications-processors/i.mx-6-processors/ \
+i.mx6qp/evaluation-kit-for-the-i.mx-6ull-applications-processor:MCIMX6ULL-EVK